Electro-Voice RE510 Frequency Response, Low Frequency Selector Switch Location Dimension Drawing

Frequency Response: Polar Response:

Microphone Use and Placement

Please note that micing techniques are a matter of personal preference. These are merely guidelines to assist in the placement of the microphone to gain optimal performance.

Usage	Optimal Placement
Vocals	Zero to six inches from the windscreen, and on
	axis with the microphone.
Spoken Word	Five to ten inches from the windscreen, and on
	axis with the microphone.

Low Frequency Selector Switch Location:

Dimension Drawing:

Standard Placement & Use Guidelines

1.Always point the microphone at the desired source of sound, and away from any unwanted sources.

2.The microphone should be located close to the sound source to minimize interference from other potential sound sources.

3.Use the 3-to-1 rule when using multiple microphones. Place each microphone three times farther from other microphones as from the desired sound source.

4.Minimize over-handling of the microphone to reduce unwanted mechanical noise.

5.Working close to the microphone will increase the bass tone and also provide increased gain-before-feedback.

RE510 Part Number: 301259-000

12000 Portland Avenue South, Burnsville, MN 55337 Phone:952/884-4051, Fax:952/884-0043

www.electrovoice.com

© Telex Communications, Inc. 6/2006

Part Number 38110-130 Rev D

U.S.A. and Canada only. For customer orders, contact Customer Service at:

800/392-3497 Fax: 800/955-6831 Europe, Africa, and Middle East only. For customer orders, contact Customer Service at:

+ 49 9421-706 0 Fax: + 49 9421-706 265

Other International locations. For customer orders, contact Customer Service at:

+ 1 952 884-4051 Fax: + 1 952 736-4212 For warranty repair or service information, contact the Service Repair department at:

800/553-5992 or 402/467-5321 For technical assistance, contact Technical Support at: 800/392-3497 or 952/736-4656

Specifications subject to change without notice.