Azden 15BT, 15XT, 105UPR, 105ULH, 15HT dimensions Operating the system

5 8

3

22

6 7 4 2

Operating the system

Because this is a frequency agile system, the receiver and transmitter must both be on the same Receive/Transmit frequency. Follow the instructions #5, 16, 24 and 27 carefully. Make sure both the receiver and the transmitter are on the same channel.

105UPR Receiver

10

24

After installing new batteries, mount the receiver to your video camera with the supplied shoe-mount or hook and loop fastener. Connect the output cable to the receiver and to the microphone input on the video camera. Switch the 105UPR to “ON” and the power indica- tor (7) should come on RED. If it doesn’t, check the batteries. When the 105UPR receives

19

9

20

1 23 21

a signal from the transmitter the LED indicator will change to GREEN. If it does not, make sure both the receiver and the transmitter are on matching Receive/Transmit frequencies.

15BT Transmitter

Plug in the supplied microphone and clip it to your subject. The microphone should be placed 4-12 inches from your subject’s mouth. Clip the transmitter to a belt using the supplied belt-clip or place it in a pocket. Switch the 15BT to “ON” and the power indi- cator should come on. If it doesn’t, check the batteries. Have someone speak into the microphone as you monitor the sound through the receiver’s phone output. If the sound is distorted, lower the MIC level on the transmitter. If there is not enough volume, raise the MIC input level on the transmitter.

28

27

+-

25

-+

13

16

14 17 15

12

18

11

15XT Plug-In Transmitter

Switch the transmitter to “ON” and the power indicator should come on. If it does not, check the batteries. Have someone speak into the microphone as you monitor the sound through the receiver’s phone output. If the sound is distorted, lower the MIC level on the transmitter. If there is not enough volume, raise the MIC input level on the transmitter.

15HT Handheld Microphone/Transmitter

Switch the transmitter to “ON” and the power indicator should come on. If it does not, check the batteries. Have someone speak into the microphone as you monitor the sound through the receiver’s phone output. If the sound is distorted, lower the MIC level on the transmitter. If there is not enough volume, raise the MIC input level on the transmitter.

Important Information

Licensing of this, or any Azden wireless equipment is the user’s responsibility. The ability to receive a license depends largely on the user’s classification, application and frequency. Contact the appropriate agency (FCC in the US) for further information.

These devices comply with Part 15 of the FCC Rules. Operation is subject to the following two condi- tions: (1) These devices may not cause harmful interference, and (2( The devices must accept Andy interference received, including interference that may cause undesired operation.

Note: The manufacturer is not responsible for any radio or TV interference cause by unauthorized modifi- cations to this equipment. Such modifications could void the user’s authority to operate the equipment.

26 26

These devices and their antenna(s) must not be co-located or operated in conjunction with any other antenna or transmitter.