Handheld MICROPHONE/TRANSMITTER 15HT | Azden 105ULH, 15XT, 105UPR

HANDHELD MICROPHONE/TRANSMITTER (15HT)

(25)Remove the battery compartment cover by rotating it counterclockwise and sliding it down.

(26)Insert two fresh Alkaline “AA” batteries into the compartment. Make sure the battery polarity is correct as marked inside the battery compartment.

Inside the battery compartment you will also find #27 and #28

(27) MIC LEVEL Control

The MIC LEVEL control enables you to adjust the audio level of the micro phone. Using the supplied tool, turn the dial clockwise to increase, or counterclockwise to decrease the microphone’s audio output level.

(28) Frequency Selection

Frequency adjustment is accomplished by setting the controls inside the bat- tery compartment. With the frequency GROUP dial on the left (column A on the included chart) you can select any of 10 frequency groups (numbered 0-9). With the frequency CHANNEL dial on the right (column B on the

included chart) you can select any of 10 frequency channels (numbered 0-9). There are actually 92 possible selections.

Thank you for purchasing Azden’s 105 wireless microphone system. Depending on which system your ordered, this package will contain one or more of the following components: the 105UPR receiver, the 15BT body-pack receiver with EX-503L lavalier microphone, the 15XT Plug-in transmitter and/or the 15HT handheld microphone/transmitter. This equip- ment is designed primarily for video cameras but can be used with most electronic com- ponents having a microphone level input. The 105UPR allows you to “receive” audio from one transmitter at a time.

RECEIVER (105UPR)

(1)Remove the battery compartment lid by sliding it down.

(2)Insert two fresh Alkaline “AA” batteries into the compartment. Make sure the battery polarity is correct as marked inside the battery compartment.

(3)POWER

Switches the receiver “ON” and “OFF”

(4) MIC OUT jack

The 105UPR is supplied with a mini-to-mini cable.

For mini jack microphone inputs: Use the supplied mini-to-mini cable. Plug one end of the cable into the receiver and the other end of the cable into the microphone input on the video camera.

For 3-pin XLR microphone inputs: Use the optional mini-to XLR cable (MX-1). Plug the mini-plug end of the cable into the receiver (use the screw-down sleeve to secure it to the receiver) and plug the XLR end of the cable into the microphone input of

the video camera.

(5) Frequency Selection

included chart) you can select any of 10 frequency channels (numbered 0-9). There are actually 92 possible selections.

(6) Phone Jack

Plug the earphone into this jack to monitor the sound. The jack is wired to work with either a mono or stereo headphone (you will hear mono in both ears when using a stereo headphone).

(7) LED indicator

This LED turns RED when the receive is turned “ON” and GREEN when receiving a signal from the transmitter.