BCWHT Handheld Microphone Transmitter
Transmitter Setup |
|
| |
Unscrew and remove the Battery Compartment |
|
| |
Cover (1) by sliding it down off the microphone to |
|
| |
expose the battery holder. Insert 2 fresh AA alkaline |
|
| |
batteries or the optional BCHRBP Battery Pack NiMH | 3 | 3 | |
rechargeable batteries, while observing the correct | |||
22 |
|
polarity as marked, and screw the cover back on the battery compartment. (Note: Make sure the transmitter is OFF when changing the batteries.)
Operation
Slide the Power Switch (2) to the ON position.The
Power LED Indicator (3) will light green, indicating that11 the transmitter is ON. In the case of dead batteries, the
indicator will be off, indicating that the alkaline batteries should be replaced with fresh ones or that the BCHRBP Battery Pack should be recharged. (Note:The optional Battery Pack should only be charged with the BCBC Charger
listed. Never attempt to recharge alkaline batteries.) The BCBC can also be used to recharge two BCWHT Handheld Microphones simultaneously.When the microphone is placed in the recharging adapter, the recharger’s LED Indicator will light bright red.The LED Indicator will light green when the batteries are charged. (Note:Always remove batteries from the BCWHT microphone when not in use.)
The microphone is now ready to use.The BCWR receiver IR LED Indicator of the corresponding channel should now be lit green. While speaking into the microphone, adjust the corresponding Volume Control on the receiver and also on your Mixer/P.A. to the desired level. For optimum performance and range, make sure that the IR emitter at the base of the transmitter is not covered by the hand and has an unob- structed
Note: Observe care in selecting volume, transmitter location and speaker placement so that acoustic feedback (howling and screeching) will be avoided.
9