DM1200/DM1235/DM1285 Rear Panel Diagram

DM1200/DM1235/DM1285

DM1200/DM1235/DM1285 REAR PANEL DIAGRAM ...

8 8 8

REAR PANEL: INPUTS AND OUTPUTS

1.Power Connector. Plug in power cord here and check the voltage level to match your country’s standard.

2.GND is the grounding lug for turntables 1, 2 and 3 (phono inputs on Channels 1, 2 and 3). Always use this connection (your turntable cable should have a grounding wire).

3.The Stereo Main Outputs are low-impedance RCA connectors controlled by the Master fader.

4.The Stereo Zone Outputs are low-impedance unbalanced RCA jacks controlled by the Zone Level control.

5.The Tape Outputs are low-impedance unbalanced RCA jacks which output the program mix and allow you to connect any recording device.

6.The S e n d can be attached to an external effects processor such as a sampler.

7.Channels 1-5 Line Inputs are unbalanced RCA jacks. The Line Input is selected with the toggle switch on the front panel. You can connect stereo audio from HiFi VCRs, cassette and reel-to-reel tape decks, DAT machines, CD players, laser discs, tuners, even synthesizers or other mixing consoles.

N O T E :Plug mono audio sources into both Left and Right inputs using a “Y” cable connector.

8.Line/Phono Input switch. Use this to allow line level equipment to be plugged into your phono inputs giving you a total of 8 line input options.

9.Phono Inputs on Channels 1, 2 and 3 use unbalanced RCA jacks. Your input signal is fed directly to the

D M 1 2 0 0's high-quality RIAA phono pre-amplifiers so use this position only for moving magnet cartridges. Line level sources will overload the sensitive phono pre-amps and will sound very bad, so always be sure to toggle the line/phono switch over to line before connection of line sources.

10.The Balanced Main Outputs are low-impedance XLR type connectors controlled by the Master fader.

11.Mic 2 is the mic input for Channel 4.

Numark - The Leader in DJ Technology

Industries

http://www.numark.com