Numark Industries EM460 owner manual Midi Functions, Touch panel X-axis

EM460

MIDI FUNCTIONS

With the factory settings, each operation will transmit the following MIDI messages.

Operation	MIDI messages transmitted			Transmission on/off
Touch panel X-axis	Pitch bend messages	En 00 00–En 7F 7F		PROGRAM MAP1
	Effect Control 1 message (CC#12)*	Bn 0C 00–Bn 0C	7F	PROGRAM MAP5
Touch panel Y-axis	Modulation 1 Depth message (CC#1) Y = 5–9	Bn 01 00–Bn 01	7F	PROGRAM MAP2
	Modulation 2 Depth message (CC#2) Y = 5–1	Bn 02 00–Bn 02	7F	PROGRAM MAP3
Touch panel	Effect 3 Depth message (CC#93)*	Bn 5D 00–Bn 5D	7F	PROGRAM MAP4
X+Y axis (diagonal)
Touch panel on/off	Effect 2 Depth message (CC#92)*	Bn 5C 7F/Bn 5C 00		HOLD switch
FX ON/OFF	Effect 4 Depth message (CC#94)*	Bn 5E 7F/Bn 5E 00		FX ON/OFF
Change Program	Program Change message (1–60)	Cn 00–Cn 38

*The MIDI messages that are transmitted can be selected in the range of CC#1–CC#31 and CC#64–CC#95. In MIDI Edit mode (￿ “MIDI transmission settings”) you can hold down the corresponding switch and rotate the PROGRAM knob to select the desired control number.

A control number that has already been assigned cannot be selected in duplicate.

MIDI transmission settings

When you press the six PROGRAM MAP keys simultaneously, you will enter MIDI Edit mode. If you then perform no operation for approximately 10 seconds or if you touch the touch panel, you will return to normal mode.

In MIDI Edit mode, you can use the following operations to change the MIDI transmission settings.

•PROGRAM knob: Set the MIDI transmission channel (1–16)

•PROGRAM MAP keys, FX ON/OFF, HOLD switches: Turn transmission on/off for each type of MIDI message (refer to “Transmission on/off” in the above table).

Precautions with the KAOSS PAD

Usage-Never press down too hard on the touch panel, or place a heavy object on it. Rough handling can cause it to crack or break. Rubbing or pressing the touch panel with a sharp object can scratch it, so only use your finger to operate it. If cleaning is necessary, wipe only with a soft dry cloth. Using solvents such as thinner may melt the surface of the touch panel. Note: Affix the included protective label to extend product life.

Location -Using the unit in the following locations can result in a malfunction.

•In direct sunlight

•Locations of extreme temperature or humidity

•Excessively dusty or dirty locations

•Locations of excessive vibration

Interference with other electrical devices -This product contains a microcomputer. Radios and televisions placed nearby may experience reception interference. Operate this unit at a suitable distance from radios and televisions.

Handling -To avoid breakage, do not apply excessive force to the switches or controls.

Care -If the exterior becomes dirty, wipe it with a clean, dry cloth. Do not use liquid cleaners such as benzene or thinner, or cleaning compounds or flammable polishes.

- The Leader in DJ Technology

©2000Industries - 9 - http://www.numark.com