3.Wires can be solid or stranded, shielded or unshielded with a minimum of
4.IR100s can be mixed and matched in larger systems with up to 10 infrared receivers, such as the IR210, IR220 or IR250.
5.To wire the system together, connect the IR100 12V, GND and SIG terminals to the corresponding IR54 or IR55 terminal. Prepare the wire leads to and from the IR100 by stripping about
¼” of the insulation from each of the three leads. Twist the strands tightly together so that they do not stick out of the connector and cause a short circuit. Strictly observe polarity. If you are connecting with the RJ45 connector you may need a RJ45 paralleling strip to parallel connect the wires from multiple IR receivers.
6.Next, plug the single or dual emitters into the IR54 or IR55 connection block.
7.IF using the RJ45/cat5 connection only you can connect the positive of a second
8.Now plug in the PS1205 for up to ten infrared receivers.
9.The infrared system is usually left plugged in all the time (to an unswitched outlet) as it uses very little power.
10.Test the infrared system to see if it is working properly. Bright sunlight and passive infrared security systems can lower the distance that remote controls can work with an IR100 receiver. If you have any questions or concerns, please call and ask for infrared technical support at 1 800 566 5579. The help line is open from 7:30 a.m. to 5:00 p.m., Monday to Friday, Pacific time.
IR100 system typical layout | RJ45 Wiring Diagram IR100 front and back |
PS1202 | RJ45 | System | LED | Receiver |
12 V DC Power Supply |
| Talkback | IR | |
| power |
|
| |
|
| on LED |
|
|
RJ 45 |
| IR55 | Receiver |
| IR31A | |
|
| |
R J45 | 12 V |
|
| G ND |
|
| SI G | CD |
|
|
Connection | IR34A |
|
Block | RJ45 | |
Note: IR100’s are |
| |
| 171 | |
wired in parallel |
| |
Dish |
| |
|
| |
| IR34A |
|