Other Functions

In addition to the reverb frequency characteristics data measured by Advanced MCACC, you can receive setting data from the receiver on your PC to check the data, and save the setting results on your PC.

Receivable measurement data

1.Speaker Setting (Setting of the speaker system and crossover frequency)

2.Channel Level (Setting of the speaker output level)

3.Speaker Distance (Setting of the distance to the speaker)

4.X-Curve (Tonal balance of the speaker system for movie soundtracks)

5.Acoustic Cal EQ (Calibration of reverb characteristics in the listening environment)

Receiving and saving measurement data

Before starting the reception, check that the receiver is properly connected to your PC (page 5), you have selected the MCACC preset you wish to apply (page 29 of the receiver manual), and that the receiver enters the transmission standby mode by the operation of the receiver (page 6).

1 Select “Other Amp Parameters” = “Receive” under “File” on the menu bar.

2 Select the number of the COM port to which the RS-232C cable is connected and click “OK”.

* If you don’t know which port number to select, try selecting each port in turn, beginning with “COM1”.

COM port selection box

Note

Refer to the operating instructions of your PC for more information about COM port settings. Data transmission starts. (It should finish in about 10 seconds.)

When reception finishes, the screen of the message “save as” appears.