The DRIVE LEVEL metering shows the recording level of the “virtual tape machine”. The display range is
The OUTPUT PPM meters show the peak level after the OUTPUT
GAIN control (see 5).
The first LED in each INPUT and OUTPUT PPM meter is a signal (SIG.) LED to indicate that a valid digital source is connected and detected. This LED helps you to verify the signal flow within a digital processing chain. If one SIG. LED is not illuminating you have a first indication of a faulty digital signal flow.
The last LED of each INPUT and OUTPUT PPM meter is a CLIP LED. The LED illuminates if the digital signal is too hot causing digital distortion.
The MACHINE HEAD allows you to store up to 99 presets, which | 9 |
| Presets |
can be changed by MIDI program change command. |
| ||
|
|
| |
If you want to store a new adjustment, depress STORE for one |
| Storing a preset: | |
second. The LED starts to flash indicating that the STORE mode |
| ||
|
|
| |
has been activated. The |
| Depress STORE for1 sec., | |
presets (including the BOOST function) before the MACHINE HEAD |
| ||
| LED flashes; | ||
was switched off the last time. Use UP and DOWN to select a |
| ||
| use UP/DOWN to select | ||
new preset number. The |
| ||
| preset no.; | ||
that the input (depressing UP or DOWN) is accepted. Keeping UP |
| ||
| depress STORE again, | ||
or DOWN depressed will let you jump through the preset list in |
| ||
| LED goes out, preset is | ||
steps of 5 presets. Once a new preset location is found depress |
| ||
| stored | ||
STORE again. The STORE LED goes out. The preset is stored at the |
| ||
|
|
| |
new location. |
|
|
|
In case you want to quit the STORE mode without storing the |
|
|
|
new adjustments simply press APPLY. |
|
|
|
If you want to apply various presets depress APPLY for one |
| Applying a preset: | |
second. The APPLY LED starts to flash indicating that the APPLY |
|
|
|
mode is activated. You can step through the preset list with UP |
| Depress APPLY for1 sec., | |
and DOWN. Once you have a preset that you want to apply |
| LED flashes; | |
depress APPLY again. The APPLY LED goes out indicating that the |
| use UP/DOWN to select | |
preset is applied. |
| preset no.; | |
In case you want to quit the APPLY mode without applying the |
| depress APPLY again, | |
new preset simply press STORE. |
| LED goes out, preset is | |
|
| applied | |
NOTE: To increase operation safety it is impossible to apply |
| Operation safety: | |
presets by simply depressing UP or DOWN. The UP and DOWN |
| Presets can not be changed | |
| by accident | ||
accepted. You have to depress STORE or APPLY for one second in |
|
|
|
order to activate the UP and DOWN buttons. |
|
|
|
Control Elements
Machine Head | 11 |