Audio-Technica ATR2500-USB instruction manual Preliminary setup with Windows XP

Page 6

Preliminary setup with Windows XP

(Service Pack 2; other operating systems may vary slightly)

1.Plug the free end of the USB cable into the USB port on your computer. The microphone’s blue LED will illuminate, indicating the mic is receiving power. Your computer will automatically recognize the USB device and install a driver.

2.In the lower right portion of your screen you may see a message that new hardware was found; or you may see a driver software installation notice.

3.To select the ATR2500-USB as your default recording device, begin at your Start menu. Select Control Panel.

Image 6

Contents ATR2500-USB FCC Warning ATR2500-USB Preliminary setup with Mac OS ATR2500-USBUSB Preliminary setup with Windows XP Select Sounds and Audio Devices ATR2500-USB Preliminary setup with Windows Vista Preliminary setup with Windows Start menu Control Panel SoundSelect Sound Following screen will pop up ATR-USB-Mic Default Device Using Headphones Additional InformationATR2500-USB Specifications† Polar PatternATR2500-USB U.S. Lifetime Limited Warranty Audio-Technica U.S., Inc