One-Year Limited Warranty

Ten Tips To Obtain The Best Results

1.Use only fresh alkaline batteries; replace the receiver batteries in pairs. Do not use “general purpose” (carbon- zinc) batteries.

2.Position the receiver so that it has the fewest possible obstructions between it and the normal location of the transmitter. Line-of-sight is best.

3.The transmitter and the receiver should be as close together as conveniently possible, but no closer together than three feet.

4.The receiver antennas should be in the open and away from any metal.

5.The transmitter and receiver must be set to the same channel number. (Use “x” units together and non-”x” units together.)

6.Only one transmitter on a given frequency should be “on” at a time.

7.The power switch on the transmitter has three positions: “Off,” “Standby,” and “On.” In the middle “Standby” position, the transmitter sends only RF to the receiver; the audio source is turned off.

8.If the “Out Level” of the receiver is set too high, it may over-drive the input of the camera/mixer or clip the output of the receiver, causing distortion.

Conversely, if the receiver output is set too low, the overall signal-to-noise ratio of the system may be reduced.

9.You need to change channels 1) when a strong interference signal is received, 2) when the channel breaks down, or 3) during multiple-system operation in order to select an interference-free channel. Always turn the units off before changing frequencies.

10.Turn the receiver and transmitter off when not in use. Remove the batteries during long-term storage.

Audio-Technica professional wireless systems purchased in the U.S.A. are warranted for one year from date of purchase by Audio-Technica U.S., Inc. (A.T.U.S.) to be free of defects in materials and workmanship. In event of such defect, product will be repaired promptly without charge or, at our option, replaced with a new product of equal or superior value if delivered to A.T.U.S. or an Authorized Service Center, prepaid, together with the sales slip or other proof of purchase date. Prior approval from A.T.U.S. is required for return. This warranty excludes defects due to normal wear, abuse, shipping damage, or failure to use product in accordance with the instructions. This warranty is void in the event of unauthorized repair or modification, or removal or defacing of the product labeling.

For return approval and shipping information, contact the Service Dept., Audio-Technica U.S., Inc., 1221 Commerce Drive, Stow, Ohio 44224.

Except to the extent precluded by applicable state law, A.T.U.S. will have no liability for any consequential, incidental, or special damages; any warranty of merchantability or fitness for particular purpose expires when this warranty expires.

This warranty gives you specific legal rights, and you may have other rights which vary from state to state.

Outside the U.S.A., please contact your local dealer for warranty details.