Kramer Electronics VP-108 user manual Define the underside controls

Your VP-108 1:8 XGA / Balanced Stereo Audio DA

Table 1: VP-108 1:8 XGA / Balanced Stereo Audio DA Features

#	Feature	Function
1	POWER Switch	Illuminated switch for turning the unit ON or OFF
2	AUDIO INPUT Terminal Block	Connect to the balanced stereo audio source
	Connector
3	XGA INPUT 15-pin HD Connector	Connect to the XGA source
4	LEFT LEVEL Trimmer	Adjust1 the left output signal level
5	RIGHT LEVEL Trimmer	Adjust1 the right output signal level
6	LOOP 15-pin HD Connector	For looping to increase output availability
7	OUTPUT Terminal Block Connectors	Connect to the balanced stereo audio acceptors (from 1 to 8)
8	OUTPUT 15-pin HD Connectors	Connect to the XGA acceptors (from 1 to 8)
9	REMOTE Terminal Block Connectors	Connect to the contact closure switches
10	RS-485Connector	RS-485 detachable terminal block port
11	RS-2329-pin D-sub Connector	Connect to PC or other Serial Controller
12	SETUP Dipswitches	Dipswitches for setup of the unit
13	Power Connector with Fuse	AC connector enabling power supply to the unit

Figure 2 and Table 2 define the underside controls:

	Figure 2: VP-108 Underside
	Table 2: VP-108 Underside Features
Feature	Function
ID BIT Switch	Set to ON position2 to select the ID BIT3
TERMINATION4 Switch	Set to ON position2 to terminate with 75￿, or move to Hi-Z for looping
EQ.4 Trimmers	Adjust1 the cable compensation equalization levels for blue, green and red
LEVEL4 Trimmers	Adjust1 the output signal levels for blue, green and red

1 Insert a screwdriver into the small hole and carefully rotate it 2 The factory default

3 Sometimes notebook computers refuse to output a VGA signal to an external VGA monitor if they do not detect the ID BIT as ON. Set the ID BIT to ON using this switch so that the notebook will output to an external VGA monitor

4 Separately for Blue (B), Green (G) and Red (R)

5