6 Connecting the VP-108 1:8 XGA / Balanced Stereo Audio DA
To connect the VP-1081:8 XGA / Balanced Stereo Audio DA, as the example in Figure 3 illustrates, do the following1:
1.Connect the XGA graphics source (for example, a PC) to the XGA INPUT 15-pin HD connector, and connect2 the balanced stereo audio source to the AUDIO INPUT terminal block connector.
2.Connect up to 8 XGA OUTPUT 15-pin HD connectors to the XGA acceptors (for example, XGA monitors), and connect2 the corresponding AUDIO OUTPUT terminal block connectors to the stereo audio acceptors (for example, pairs of stereo loudspeakers).
3.Connect the LOOP 15-pin HD connector (OPTIONAL) to the XGA INPUT 15-pin HD connector on an additional unit to increase video outputs.
4.Set the dipswitches (see section 6 .2.1).
5.Set the switches on the underside for looping3 (see Figure 2).
6.Connect the power cord4.
7.Adjust the left and right audio signal levels, if required.
8.If required5, connect a PC and/or controller to the RS-232 port (see section 6 .2), and/or the RS-485 port.
9.If required, connect a remote contact closure switch (see section 6 .3).
1 Switch OFF the power on each device before connecting it to your VP-108. After connecting your VP-108, switch on its power and then switch on the power on each device. Switching on the VP-108, recalls the last status prior to powering down 2 See section 6 .1 for a description of how to connect a balanced/unbalanced stereo audio input/output
3 The default settings are for non-looping
4 The power connector is not illustrated in Figure 3 5 Not illustrated in Figure 3
7
