part of American DJ’s new commercial series fog machines with patented Electronic Thermo Sensing (E.T.S.), for continuous heating regulation.
Functions:
The new Commercial Series MASTER BLASTER™ fog machines all come with E.T.S., for
continuous
timer remote control, that comes mounted into the unit. The remote may be removed, by unscrewing the four (4) thumb screws that hold it to the base. The unit also contains a removable, one quart reservoir.
Electronic Thermo Sensing / E.T.S.:
This feature allows you to have fog output available at almost any time. A small on board micro processor constantly monitors the operating temperature of the fog machine. When the fog machine drops ONE (1) degree in temperature the E.T.S., automatically senses this change and turns the heater on to raise the temperature that one degree lost. This enables the end user to have fog output at anytime. The only time fog will not be available, is at the end of the machines duty cycle (The fog output was maxed out and the heater has to reheat completely).
Operating and Remote Instructions:
Plug your fog machine into a standard 110V/120V supply. The remote control comes con- nected to the fog machine but can be removed to access the 25ft. cord. Make sure there is an adequate supply of American Fog Juice™ in the fluid reservoir. Running the fog machine dry will cause pump failure and or clogging. This is the largest cause of failure in fog machines. Only American Fog Juice™ is recommended and not all fog juice is created equal. Once the machine is plugged in and turned on, a red L.E.D. will indicate the unit is receiving power. The unit has a warm up time of five (5) minutes. After the unit has warmed up, a GREEN L.E.D on the remote will light indicating the unit is ready to emit fog. To emit fog, simply press the green button on the remote for desired length of time. If the GREEN L.E.D. is on and fog does not come out after holding the button down for 30 seconds, check the fluid tank and hose to make sure there is fluid going through the hose. You can also operate the fog output automatically by adjusting the timer settings on the remote.
The remote has three (3) L.E.D.s that indicate different functions; The YELLOW L.E.D. will indi- cated the timer is turned on and is activated. The RED L.E.D. indicates power is on. The GREEN L.E.D. indicates fog output is available. The remote also contains two rotary knobs. The Duration knob serves two functions 1) Turns the timer on and off. 2) Sets the timers dura- tion (Length of fog output). The interval knob sets the amount of time in between fog out- put from 30 seconds to 10 minutes.
Caution: Before removing or replacing the remote unit disconnect the power supply.
Affordable Quality Lighting Products from American DJ Supply, Inc. Los Angeles, CA. 90058 Page 2