Behringer B512DSP user manual Installation, Other uses

Page 9

EUROLIVE B512DSP

Linking several B512DSP:

If you need more sound pressure, for example in larger rooms, simply increase the number of loudspeakers on each stereo side. You could place two B512DSP on each stereo side and interconnect them (see Fig. 4.3). The loudspeakers can be stacked or placed one beside the other. When you stack the speakers, the carrying recesses built into the cabinets ensure the stability of the stack. You can connect a microphone, a mixing console or stereo signal source.

sConnect the LINE OUT connector of the first B512DSP to the MIC/LINE input of the next B512DSP.

+With several B512DSP speakers connected to each other, their input impedance will be reduced by half (two B512DSPs), or to one third (three B512DSPs), etc. Always use the output impedance of the mixing console as a basis for your calculations!

Fig. 4.3: Linking several B512DSP speakers

4.3 Other uses

Monitoring:

When used as a monitor, the B512DSP receives its audio signal from the monitor or aux output of the mixing console. If additional B512DSPs are to be used, you can loop the audio signal from the first speaker to the next B512DSP using the line output. The sound and volume of each B512DSP can be adjusted with their own operating elements (LEVEL), (EQ HIGH) and (EQ LOW).

Keyboard amplification:

Guitarists and bassists usually have their own amplifiers on stage to make sure they can hear their own instrument—even when no monitors are used. In particular on smaller stages, the power delivered by these amps is enough to match the volume produced by other sound sources on stage. Things are different with keyboards and synthesizers as these usually have no built- in speakers. The B512DSP allows you to connect and mix two keyboards. If you want to play more than two keyboards, you can use a submixer (e.g. MicroMIX MX400) to mix down the signals and route them to the B512DSP using submixer output connectors. The second MIC/LINE input can be used to connect the monitor signal from the PA mixing console, so that you can also hear the other members of your band.

5. Installation

Both audio inputs and outputs of the BEHRINGER B512DSP are fully balanced. To maximize interference compensation, try to establish balanced connections to other equipment, whenever possible.

+Make sure that only competent people install your B512DSP. They must be sufficiently earthed during and after the installation process. Otherwise, electrostatic discharges may negatively affect the operating characteristics of your equipment.

Fig. 5.1: XLR connector

5. Installation

9

Image 9
Contents B512DSP Eurolive Eurolive B512DSP Important safety instructionsEurolive Foreword Table of contentsIntroduction Before you get startedIntroduction Control elements and connections Control elements and connectionsSpeech MusicHow to avoid feedback Setting up the B512DSPSetting up the B512DSP TweeterApplication examples PresentationsPA systems Installation InstallationOther uses Specifications Warranty WarrantyEurolive B512DSP