AmpliVox manual Roving Rostrum P.A, Models S132A Includes, Set Up

Page 1

ROVING ROSTRUM P.A.

PORTABLE PUBLIC ADDRESS SYSTEM

MODELS S132A

INCLUDES:

Carrying case with fold down legs and built-in speakers

Multimedia Stereo Amplifier

Professional Cardioid microphone

Gooseneck microphone holder

Extension speaker with 40ft cable

CD Player

Cassette Tape Player

SET UP:

INSTALL POWER SUPPLY

The Battery pack is standard. Optional Power Supplies may be substituted: Model S1460, International AC Adapter/Recharger (110/220V, 50/60Hz). Model S1462, 12 Volt DC adapter (automotive cigarette lighter plug-in). Model S1465, NiCad Battery Pack

TO INSTALL OR REPLACE BATTERIES

Remove Reading board. Loosen two wing nuts on battery holder bracket. Remove battery holder from amplifier. Insert 10 new Alkaline “D” cell batteries, be sure to observe polarity, or replace with Model S1465, NiCad battery pack. Carefully replace battery pack. Replace battery holder bracket. Tighten two wing nuts and replace reading board.

Do not mix battery types or attempt to recharge alkaline batteries - equipment damage, safety hazard or fire could result.

CD, CASSETTE PLAYER

Each requires AA batteries loaded on the backside of each unit.

TO OPERATE:

Plug microphone into DYNAMIC microphone jack. Plug the extension speaker lead into right SPEAKER jack. Turn amplifier on (large rocker switch located on the front of the amplifier). The red light will go on, showing that power is available. Rotate VOLUME control knob to obtain desired loudness level throughout the coverage area.

ON-OFF

When power switch is in the ON position, the red light will be on.

DC IN

Connection for optional power adapter:

S1460 International AC Adapter/Recharger (110/220V, 50/60Hz)

S1462 12 Volt DC (automotive cigarette lighter) Adapter

Image 1
Contents Roving Rostrum P.A SET UPModels S132A Includes Problem Solving VolumeLamp Microphone Inputs