ISOLATOR SECTION
25, HI SWITCH
Allows cutting off the sound of treble range. Sound volume will be cut when the switch is set downwards. When the switch is put back, the output volume returns to normal. Can be useful for cutting off the sound of the cymbals or high hats for example.
26, MID SWITCH
Allows cutting off the sound of the middle range. Sound volume will be cut when the switch is downward position. When the switch is put back, the output volume becomes normal sound volume. Can be used for cutting off vocal and melody from the source.
27, LOW SWITCH
Allows cutting off the sound of the bass range. Sound volume will be cut when the switch is set downward. When the switch is put back, the output volume return to normal. Can be utilized for creating the effects of an acapella.
ISOLATOR SECTION
PGM1 ISOLATOR
LOW MID HI
27 | 26 | 25 |
REAR PANEL
28 |
| 30 |
| 31 |
|
|
|
|
|
|
POWER |
|
|
|
|
| AC100V | 50 / 60Hz 16W | |||
|
| MADE IN JAPAN | SERIAL NO. |
|
| |||||
|
|
|
|
| ||||||
|
|
|
|
|
|
|
| |||
ON |
| OUTPUT | EFFECT |
| PGM 2 |
| SUB | PGM 1 |
| |
OFF | MASTER OUT 1 | SEND | R | LINE 6 | L |
| R | LINE 2 | L | |
R | L | R | L |
|
|
|
|
|
| |
|
|
|
|
|
|
| ||||
|
|
|
|
|
| R | LINE 3 | L |
|
|
34
AC 100V
| LINE 5 |
| LINE 1 |
|
R | L |
|
| 33 |
MASTER OUT 2 | PHONO 3 | PHONO 2 | PHONO 1 |
|
| RETURN |
|
|
|
|
| GND | GND | 35 |
|
|
|
29
32
REAR PANEL
28.POWER SWITCH
The first LED of MASTER OUT LEVEL METER that is located on the top panel is lit when on.
29.AC POWER CABLE
30.OUTPUT JACK(1/4inch PHONE JACK, RCA PIN JACK) Connect to the input of power amplifier.
31.EFFECT SEND JACK
Connect the SEND jacks to the input of an external effector unit(Delay,Reverb etc)
32.EFFECT RETURN JACK
Connect the RETURN jacks to the output of the effector.
33.PHONO INPUT JACK
Input jack for PGM1,PGM2 and SUB channel turntables.
Connect turntables equipped with the MM pick up certridge only.
34.LINE INPUT JACK
Input connectors for the line level equipment such as CD players, tape decks, DATs, MDs.
35, GROUND TERMINAL
Connect this terminal to the ground lead of the turntable. This helps to redusce noise and hum.