Selectable Options

The eight channel Monitor Sends are factory set as POST FADE, but may be altered to PRE FADE in blocks of four (1-4 and 5-8) by repositioning a link on the Input PCB SC3005 as shown below, after removing the PCB from the console.

INPUT BOARD SC3005

PRE	POST
J1	J2
	L9
C28	R56
	R56
C27	R54
	R54

C21
R51	R50

PRE POST

J1J2

R48

				J4
R44	R45	R47		POST
			R55	POST

PRE J3

POST J4

PRE J3

To change Sends 1-4 to PRE FADE carefully unsolder link J4 using the minimum of heat to avoid the possibility of tracks lifting on the PCB. Replace the link in position J3.

To change Sends 5-8 to PRE FADE carefully unsolder link J2 using the minimum of heat to avoid the possibility of tracks lifting on the PCB. Replace the link in position J1.

This operation should only be carried out by competent technicians who possess the necessary soldering skills.

Page 25