SoundCraft Spirit Monitor manual Talkback Gain, ALL Talkback, All Dim, PFL Active LED, PFL Trim

	or plugged in via a cable.
6.	BARGRAPH METER
	A sixteen segment, three colour bargraph meter provides vis-
	ual monitoring of WEDGE/PFL level. Normally the post-fade
	Wedge signal is displayed, unless any PFL switch is active, in
	which case the PFL signal is shown. The level of the dis-
	played Wedge signal follows the actual Wedge output,
	including the effect of the Dim circuit if active. The bargraph
	may be calibrated by a trimmer accessed via a hole in the
	panel above the meter. Adjustments may be made using a
	small screwdriver, taking care not to damage the trimmer.
7.	TALKBACK GAIN
	Sets the level of Talkback microphone signal which may be
	routed to any Monitor Output.
8.	ALL TALKBACK
	Pressing the ALL T/B switch dims all monitor outputs and
	adds the Talkback mic signal, also dimming the wedge output
	to prevent feedback. Note that ALL T/B is disabled when
	ALL DIM is pressed.
9.	ALL DIM
	Pressing ALL DIM attenuates all outputs, except the wedge
	output. This provides an instant remedy for serious feedback,
	while the source of the problem is identified.
10.	PFL ACTIVE LED
	The LED illuminates whenever a PFL switch is pressed to
	show that the Wedge and Phones outputs and the
	Wedge(PFL) bargraph are now receiving the PFL signal.
11.	PFL TRIM
	The rotary PFL TRIM control provides level adjustment of the
	PFL signal to allow for differences in operating levels. The
	TRIM control has no effect on the level of PFL signal fed to the
	Wedge(PFL) meter.
12.	SUB TRIM
	The rotary SUB TRIM control provides level adjustment of the
	engineer’s Submix. The TRIM is pre-insert and pre-fader, and
	will therefore affect both the level at the wedge output and

Page 19