Stanton RM-406 owner manual Section H Channel Controls

RM.406 Top Panel (FUNCTIONS)

Section H: Channel Controls (continued)

this setting too high may result in a loss of sound quality (distortion.) [Note: For best results set this control in the number 7 (2 O'Clock) position for unity gain. If further adjustment is needed, this is a good reference point.]

37.Channel EQ (MID): Controls Mid frequency equalization of correspon-

ding channel (+9/-64 dB.) [Note: -64dB = complete KILL of frequency. Any changes made to EQ settings will affect the overall output level of this chan- nel]

38.Channel Input Meter: Displays the input level of this channel. The input level is determined by the Channel Gain controls (see #36.) Red indicates clipping.

39.Channel EQ (LOW): Controls Low frequency equalization of correspon- ding channel (+9/-64 dB.) [Note: -64dB = complete KILL of frequency. Any changes made to EQ settings will affect the overall output level of this chan- nel]

40.Send FX: Turns the effect send ON / OFF for this channel. This switch routes the audio signal to the effects send bus (#3), for use with external effects processor / FX Loop (see Section B.)

41.Cue (assign): Selects the channel to be monitored via headphone Cue (Section D.)

42.Channel Fader (Line Fader): Controls the output level of the correspon- ding channel. This control is Post-EQ and when NOT using Crossfader Assign (#43) the signal is sent directly to the master output.

43.Crossfader Assign (A-B- BYPASS): Controls where the audio signal for this channel will be sent; either to the Crossfader (#19) or to Master Output (#6.) When set to A, this channel will be assigned to the left side of the Crossfader; When set to B, this channel will be assigned to the right side of the Crossfader. When set to BYPASS, the Crossfader will be bypassed alto- gether and the audio is sent straight from the Line Fader (#42) to the Master Output (Section C.) [Note: This allows the DJ to mix with or without using the Crossfader].