SoundCraft D-Mix 500 manual

Page 2

© Harman International Industries Ltd. 1996,1997 All rights reserved

Parts of the design of this product may be protected by worldwide patents.

Part No. ZM0143 Issue 3

Soundcraft is a trading division of Harman International Industries Ltd.

Information in this manual is subject to change without notice and does not represent a commitment on the part of the vendor. Soundcraft shall not be liable for any loss or damage whatsoever arising from the use of information or any error contained in this manual.

No part of this manual may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, electrical, mechanical, optical, chemical, including photocopying and recording, for any purpose without the express written permission of Soundcraft.

It is recommended that all maintenance and service on the product should be carried out by Soundcraft or its authorised agents. Soundcraft cannot accept any liability whatsoever for any loss or damage caused by service, maintenance or repair by unauthorised personnel.

Harman International Industries Ltd.

Cranborne House,

Cranborne Road,

Cranborne Industrial Estate,

Potters Bar,

Herts.,

England.

EN6 3JN.

Tel: 01707 665000

Fax: 01707 660482

Image 2
Contents Soundcraft Page Table of Contents Page Introduction MIX500 IntroductionChannels Power SuppliesIntroduction MeteringFront Panel Warranty Installation MIX500 InstallationDimensions Power Supply InstallationWiring Considerations Power Supplies & Cables Precautions and Safety InstructionsGeneral Precautions Signal Levels Connecting The Inputs Examples ExampleConnecting The Outputs An Example Connecting the DJ System Outputs An Example Jack Sockets Wiring conventionsConnections Phono Plugs XLRsPhono Sockets Impedance Balanced To BalancedMIX500 Installation MIX500 System Block Diagram System Block Diagram Functional Descriptions MIX500 Functional DescriptionEqualisation Stereo Input Channels 1 & 7 CD/AVInput Stage Channel OutputStereo Input Channels 2 & 6 VINYL/CD Mono Input Channels 3 & 4 MIC/LINE Input Make sure the channels you wish to send to FX are on Stereo Input Channel 5 Vinyl 3/INPUT C Theoutputofthischannel Cannot Beassignedtothecrossfader Master Section Outputs Master Section Cross Fader MonitoringInputs MIX500 Functional Description Specifications MIX500 SpecificationsTypical Specifications