SoundCraft D-Mix 500 manual Theoutputofthischannel Cannot Beassignedtothecrossfader

Page 29

Stereo Input Channel 5 - VINYL 3/INPUT C

Input Stage

(9)The input switch selects the input source. When this switch is pressed INPUT C has been selected and the LED to the right of the switch lights up orange. When the switch is released a green LED will illuminate thus meaning the VINYL 3 Input source has been selected.

(10)Gain- Adjusts the level of the selected input by +/-10dB and should be set up carefully to ensure a good signal level to the rest of the mixer. If it is set too high the signal will distort as it overloads the channel and causes clipping. If it is set too low the level of any background hiss will be more noticeable and you may not be able to get enough signal level to the output of the mixer.

Equalisation

(11)The Equaliser (EQ) allows precise manipulation of the sound.

Three EQ bands are provided, HF (High Frequency), MF (Mid Frequency) and LF (Low Frequency). These EQ bands provide 15dB of cut and boost at 10kHz, 1kHz and 80Hz respectively on the D-MIX500; 5dB cut and boost at these frequencies on the D-MIX500L.

Channel Output

(12)The Peak LED warns the DJ of excessive signal level in the channel before distortion occurs. The signal is sampled just after the EQ section, and illumination of the LED will indicate that the input sensitivity is set too high, or that the EQ settings are too extreme.

(13)The Channel ON switch enables and disables the channel. When the switch is set to the on position a green LED will illuminate showing the channel is active.

(14)The CUE switch enables the pre-fade channel signal to be routed to the DJ’s headphones and booth monitors if required.

(15)The Output signal level from the channel is set by the Fader.

THEOUTPUTOFTHISCHANNEL CANNOT BEASSIGNEDTOTHECROSSFADER

D-MIX500 Functional Description

4.7

Page 28 Page 30
Image 29
Page 28 Page 30
Contents Soundcraft Page Table of Contents Page MIX500 Introduction IntroductionIntroduction Power SuppliesChannels MeteringFront Panel Warranty MIX500 Installation InstallationDimensions Power Supply InstallationWiring Considerations Power Supplies & Cables Precautions and Safety InstructionsGeneral Precautions Signal Levels Example Connecting The Inputs ExamplesConnecting The Outputs An Example Connecting the DJ System Outputs An Example Jack Sockets Wiring conventionsConnections XLRs Phono PlugsImpedance Balanced To Balanced Phono SocketsMIX500 Installation MIX500 System Block Diagram System Block Diagram MIX500 Functional Description Functional DescriptionsInput Stage Stereo Input Channels 1 & 7 CD/AVEqualisation Channel OutputStereo Input Channels 2 & 6 VINYL/CD Mono Input Channels 3 & 4 MIC/LINE Input Make sure the channels you wish to send to FX are on Stereo Input Channel 5 Vinyl 3/INPUT C Theoutputofthischannel Cannot Beassignedtothecrossfader Master Section Outputs Master Section Cross Fader MonitoringInputs MIX500 Functional Description MIX500 Specifications SpecificationsTypical Specifications
Top Page Image Contents