Connecting the SCS.3m
2.Connecting the SCS.3m
Before you connect power, you will need to remove the SCS.3m Back Panel:
To open back, first look for 2 knobs and turn them so that they are oriented vertically. When booth knobs are turned, remove the back by pulling the bottom of the panel up. (Figure 2.1)
When the Back Panel is off, you will see the following sockets:
(2) USB type “A” sockets
(1) USB type “B” socket
(1) 8 mm 12 VDC power supply socket
Figure 2.1
2.1Connect USB
Connect the USB type “B” connector to the SCS.3m USB “B” socket and the other end of the USB cable to your computer’s USB port. No drivers are required so your computer should automatically install the SCS.3m. (Figure 2.2)
Figure 2.2
2.2Connect Power
Before connecting other devices, connect the SCS.3m to power using the included wall adaptor. It is important to always use the wall adaptor when plugging additional devices to the USB hub. (Figure 2.3)
Figure 2.3
3