Mounting

To install the UHF-8800 to a 19” rack case, complete the steps below.

1. Align the UHF-8800 with the desired space in rack and slowly slide in, rear panel first.

NOTE: Depending on your rack case design, it may be neces- sary to allow for sufficient space for the antennas.

2.While aligned, use rack case screws (not included) in the order shown below to stabilize the UHF-8800 in its space, using the “X” rotation (numbered below) will ensure even tension and plush alignment.

NOTE: Do not tighten screws firmly until all screws are in place.

�	�
�	�
	�