Before Getting Started Things to Consider

Before Getting Started: Things to Consider

It is very important to read the following instructions prior to starting any installation procedures. Doing so will ensure a correct installation and may save you some time as well.

Protect Against Power Surges

•Connect all external components before you plug any of their power cords into the wall outlet.

•Turn off the DA-2277 before you connect or disconnect any cables.

•Make sure all cables are properly grounded.

Protect Components from Overheating

•Don’t block ventilation holes. Arrange any components so that air can circulate freely.

•Don’t stack components.

•If you place the DA-2277 on a stand, make sure you allow adequate ventilation.

Position Cables Properly to Avoid Audio Interference

•Insert each cable firmly into the designated jack.

•If you place components above the DA-2277, route all cables down the side of the back of the DA-2277 instead of straight down the middle of the back of the DA-2277.

Important Stand and Base Safety Information

Choose the location for your DA-2277 carefully. If the DA-2277 is placed on a stand or base, ensure that it is of adequate size and strength to prevent it from being accidentally tipped over, pushed off, or pulled off. This could cause personal injury and/or damage to the DA-2277.

Unpacking the DA-2277

First carefully unpack all of the box contents. You should have found the following items with your new DA-2277:

1 DA-2277 Receiver

2 Wireless Microphone Transmitters

2 RCA A/V Patch Cables

1 Four-Pack of AA Rechargeable Batteries

2 Mounting Brackets

7 Mounting Bracket Screws

	Delay		Repeat		Digital Echo				Mic 4
0	10		0	10		0	10
								Echo On
9		5			0			0
	0	10		-15	+15		-15	+15
	Mic Master			Bass			Treble		Mic 4 Input