VocoPro owner manual Getting Started, Setting Up the UHF-388, Connecting the Antennas

Getting Started

Caution: Before connecting the power supply, make sure that the power switch on the reciever is switched OFF. Note:For additional protection, it is recommended that you plug in the power supply to a surge protector/Power strip.

Setting Up the UHF-388

Set up the UHF-388’s receiver in a spot where there are no barriers above the antennas or between the receiver and the microphones. Make sure you have enough space above the receiver to charge the micro- phones. NOTE: Do not place the UHF-388 in a space where there is something above the antennas such as a rackspace or an entertainment center.

UHF-388

UHF-388

Connecting the Antennas

1.Line up the slots on the antenna’s BNC connector (Fig. B) with the pegs on the receiver’s BNC inputs (Fig. C) and push in.

2.Twist the antennas BNC connector “clockwise” until it locks in to place 3.Repeat steps 1 and 2 for the second antenna.

CHANNEL B

ANT. B

Fig. B - Close-up of Antenna BNC Fig. C - Close-up of BNC Input on Face of UHF 388

6