Acesonic AM-170 user manual Remote Control Operations, Care & Maintenance

Page 4

6.AUDIO OUT – RCA jacks for Audio out.

7.REC OUT AND LINE OUT – These RCA jacks are for sending Audio to external recording units or other devices.

8.SUB AND MIC OUTPUTS – The SUB RCA jacks send Audio signals of appropriate frequency

to subwoofers. The MIC jacks send High and Low signals to other audio devices.

9.SPEAKER CONNECTIONS – The Left and Right pairs of posts connect to your speakers.

10.SOURCE INPUTS – The jacks in this location accept inputs from BGM, AUX, DVD and CDG.

11.S-VIDEO OUT – This output jack sends an

S-Video signal for input to TVs and TV-connected devices that use the format.

12.VOLTAGE SELECT – This switch selects be- tween 115 and 230 volts for AC power.

13. AC INPUT – This is where the power cord con- nects to the back of the AM-170.

Remote Control Operations

1.KEY CONTROL – The b and # keys adjust the pitch up and down by semitones, while the center selection (natural symbol) returns the program material to its original key.

2.MIC VOLUME – The + and - buttons control the Volume of the microphone(s) being used.

3.MUSIC VOLUME – Increase or decrease

the music master output Volume with the + and - buttons.

4. SOURCE SELECTIONS :

• The AUX button selects the external source con- nected to the AUX INPUT on the back panel.

The BGM button selects the external source connected to the BGM INPUT on the back panel.

• The DVD button selects the external source con- nected to the DVD INPUT.

The AUTO button enables the automatic input detection on the AM-170 to select the source.

• The CDG button selects the external source con- nected to the CDG INPUT on the back panel.

5.3D SOUND – This button toggles the 3D Sound enhanced audio between off and on.

6.MUTE – This button toggles Mute between off and on.

7.MPX – This button selects the various Audio mix settings, toggling among Stereo, Left and Right.

1

2

3

4

5

6

7

Care & Maintenance

Use only a slightly dampened cloth to clean the AM- 170, and dry off with a clean towel. Keep the unit in an area free of excessive moisture, and always allow

sufficient room around the unit for airflow. This will prevent the AM-170 from overheating.

As with all audio and electronics gear, do not use the device except as described in these instructions.

4

Image 4
Contents Table of Contents Watt Professional Mixing AmplifierProduct Features Initial Setup ConsiderationsIncluded Accessories System ComponentsFigure a Refer to the Figure B directly aboveRemote Control Operations Care & MaintenanceTroubleshooting SymptomSolutions Possible CauseMicrophone Frequency Response Connecting the AM-170Music Frequency Response FCC Advisory, Safety Warnings & Safe Use Safe Use InstructionsAM-170