Omega Speaker Systems OME-DB-889D manual Jumper setup, 1 JP0 ~ JP15 Analog Input R/C Filter

2.2 Jumper setup

2.2.1 JP0 ~ JP15 Analog Input R/C Filter

The OME-DB-889D provides R/C filter with each analog input channel by jumper

setting.

Channel 0 High

Channel 0 Low

1.2KΩ

1uF 50V

1.2KΩ

JP0~JP15

Short : with filter	Open : Without filter
Default setting

2.2.2 JP16 Analog Output Channel Jumper

The OME-DB-889D supports 10 separate jumper to select output channel, This feature permits up to 10 OME-DB-889D’s be connected to a 10 channel analog input card. Place the jumper in the output channel according to the channel of the analog input card selected for that OME-DB-889D board. The following table illustrates the jumper setting of using the OME-DB-889D with the OME-A-82X series.

	JP16	JP17
X	Analog output	CJC output X
A/D CH0		0
A/D CH1		1
A/D CH2		2
A/D CH3		3
A/D CH4		4
A/D CH5		5
A/D CH6		6
A/D CH7		7
A/D CH8		8
A/D CH9		9

If none of the output channel is used, leave the jumper in position “X”. If the CJC output is required for the thermocouple applications, be aware that the analog output and CJC output share the connector for the analog output and the CJC output.

Note: “X” means channels are not supported by the OME-A-82Xseries

OME-DB-889D User’s Manual 5