WM-120P/S — CONTROLS
Figure 1. Mixer
Safety Grill — Provided for operator safety. This safety grill is designed to keep hands and solid objects out of the mixing drum when in use.This grill should be closed at all times when mixer is in use.DO NOT remove the grill or grill opening bar.Keep the grill clean by washing it down daily.
Bag Cutter— This feature allows compound mixing bags to be opened easily, therefore allowing the contents of the bag to fall directly into the mixing drum.
Mixing Paddles — Used in the mixing of material. This unit uses four different types of paddles to provide a fast uniform mix.
Dump Handle — Pull this handle downward to dump the contents of the drum. Push the handle upward to return the drum to its vertical position.
Zerk Fitting — There is, on each end of the mixing drum a zerk grease fitting.These fittings lubricate the dumping mechanism. Lubricate both fittings at least twice a week.
Mixing Drum — Made of either polyethylene or steel. Mixing materials such as concrete, mortar, plaster are to be placed into this drum for mixing. Always clean the drum after each use.
Tow Bar — When towing is required, connect tow bar to a vehicle Reference page 14.
Engine Cover — Lift this cover to gain access to the engine compartment.
ON/OFF Switch (gasoline)
ON/OFF Switch (electric) — This switch is provided on mixers with electric motors.To gain access to this switch, lift the engine cover.When activated it will shut down the electric motor.
Clutch Lever — Push the clutch lever forward, toward the tow tongue end of the mixer to engage clutch. Once clutch is engaged paddle shaft will rotate.To disengage clutch pull the clutch backwards towards the engine.