Stow MS15H5.5 manual MS15H/MS15E Mixer Electric Motor

Page 17

MS15H/MS15E MIXER — ELECTRIC MOTOR

Electric Motor

For maintenance care and operation of the electric motor, refer to your electric motor instruction booklet furnished with the motor.

Protect the electric motor from dust as much as possible and keep ventilating openings clean.

 

CAUTION

Electric Motor

 

Safety

DO NOT spray water at any time on the electric motor.

DO NOT operate electric motor in a explosive environment.

The electric motor used in this mixer is a single-phase 1.0 HP motor. The input voltage requirement for this motor is either 115 or 230 VAC only.

Electric Motor Connection

A 12 inch electrical cable (Figure 3) with a pigtail at one end is provided with the electrical motor for hookup to a power source. Table 2. shows the required NEMA connector for the desired motor horsepower rating. In addition, Table 3 also shows the matching NEMA approved connector for the required extension cord.

ALWAYS, make certain that the power source required for the electric motor is correct and always use the correct NEMA configuration plug. Failure to supply the correct voltage to the motor can severely damage the motor.

The motor supplied is wired for 115 VAC grounded operation. Make certain that the correct size grounded (3-wires) extension cord is used. See Table 4.

Motors can burn out when the line voltage falls 10% below the voltage rating of the motor. Failure to use proper voltage will cause the motor to overheat and actuate the overload switch.

If overload protection should actuate because of improper voltage or any other malfunction, turn the main switch on the motor to the "OFF" position and correct the problem, press the reset switch button, and turn the main switch to the "ON" position.

It is strongly recommended that all electrical wiring be done by a licensed

NOTE electrician.

Electric MotorVoltage Switch

1.ALWAYS make certain the motor switch is "OFF" and the power cord has been disconnected from the power source.

2.Remove the voltage lock-out bolt (Figure 2). Change the position of the voltage change toggle switch from 115 VAC to 230 VAC. The mixer is factory wired for 115 VAC operation.

3.Replace the voltage lock-out bolt.

4.Important!, when changing the input voltage to the motor from 115 to 230 VAC the plug on the motor power cord must also be changed. See Table 3.

Table 3. Electric Motor Wiring Information

Motor

115-230 VAC - Single Phase

Horsepower

 

 

NEMA Plug Connector

Mating NEMA

Rating

 

Receptacle Connector

 

 

 

 

 

1.0 HP

L5-20P P/N EM940537

L5-20R P/N EM940538

(115 VAC)

 

 

 

 

 

1.0 HP

L6-20P P/N 940539

L6-20R P/N 940540

(230 VAC)

 

 

 

 

 

Table 4. Recommended Extension Cord Sizes

Model

Motor

Voltage

50 ft.

75 ft.

100 ft.

200 ft.

(15.24 m)

(22.86 m)

(30.48 m)

(60.96 m)

 

 

 

 

 

 

 

MS15E

1.0 HP

115

No. 12

No. 10

No. 8

No. 6

 

 

 

 

 

(Electric)

 

 

 

 

 

230

No. 14

No. 12

No. 12

No. 8

 

 

 

 

 

 

 

 

 

CAUTION

Electric Motor

Connections

 

ALWAYS make certain that the power source required for the electric motor is correct and always use the correct NEMA configuration plug. Failure to supply the correct voltage to the motor can severely damage the motor.

MQ STOW MS15H/MS15E MIXER — PARTS & OPERATION MANUAL — REV. FINAL (08/10/06) — PAGE 17

Image 17
Contents PLASTER/MORTAR Mixer Page Heres HOW to GET Help Table of Contents When ordering parts Please supply the following information MS15H/MS15E Mixer Parts Ordering ProceduresMS15H/MS15E Mixer Specifications MS15H/MS15E Mixer Dimensions Burn Hazards HazardsEquipment Damage MS15H/MS15E Mixer Safety Message Alert SymbolsRead this manual MS15H/MS15E Mixer Rules for Safe OperationStand Clear Mixer when in useMS15H/MS15E Mixer Rules for Safe Operation MaintenanceMS15H/MS15E Mixer Operation and Safety Decals MS15H/MS15E Mixer General Information Mixer Components MS15H/MS15E Mixer Mixer ComponentsMS15H/MS15E Mixer Basic Engine Components Electric Motor MS15H/MS15E Mixer Electric MotorMS15H/MS15E Mixer Electric Motor Paddle Blade Adjustment, Steel Drum MS15H/MS15E Mixer Paddle Blade AdjustmentEyesight and Hearing Before StartingInspection Explosive FuelControls Start/Stop Switches Start/Stop SwitchBelt Check Blade CheckMS15H/MS15E Mixer START-UP Procedures Do not Disconnect Stopping the Mixer Electric MotorEngine Maintenance Schedule MS15H/MS15E Mixer Maintenance EngineDrum Head Seals Grease Fittings Zerk Maintenance Electric MotorCountershaft Bearing Lubrication Drum Bearing Bracket LubricationMS15H/MS15E Mixer Maintenance Mixer MS15H/MS15E Mixer -TROUBLESHOOTING Engine MS15H/MS15E Mixer -TROUBLESHOOTING Engine MS15H/MS15E Mixer -TROUBLESHOOTING MIXER/MOTOR MS15H/MS15E Mixer -WIRING Diagram Electric Motor Page Items Found In the Remarks Column Explanation of Code in Remarks ColumnMS15H/MS15E Mixer 1TO 3 Units With Honda GX160K1HX2 Engine MS15H/MS15E Mixer Suggested Spare PartsMS15H/MS15E Mixer Nameplate and Decals Part Name MS15H/MS15E Mixer Steeltub Assy MS15H/MS15E Mixer Steeltub Assy MS15H/MS15E Mixer Paddle Shaft Assy Paddle Shaft MS15H/MS15E Mixer Frame Assy Part Name QTY MS15H/MS15E Mixer Engine Cover Assy Retainer Chain MS15H/MS15E Mixer Honda Engine Assy Honda Engine Assy MS15H/MS15E Mixer Electric Motor Assy Pillow Block Honda GX160K1HX2 Engine Cylinder Head Assy Part Name QTY Remarks Honda GX160K1HX2 Engine Cylinder Barrel Assy Switch ASSY. OIL Level Honda GX160K1HX2 Engine Crankcase Cover Assy GASKET, OIL Filler CAP Honda GX160K1HX2 Engine Crankshaft Assy Crankshaft H- Type Honda GX160K1HX2 Engine Piston Assy Ring SET, Piston STD Honda GX160K1HX2 Engine Camshaft Assy ROD, Push Honda GX160K1HX2 Engine Recoil Starter Assy REEL, Recoil Starter Honda GX160K1HX2 Engine FAN Cover Assy PLATE, Side STD Honda GX160K1HX2 Engine Carburetor Assy Gasket SET Honda GX160K1HX2 Engine AIR Cleaner Assy Gasket Elbow Honda GX160K1HX2 Engine Muffler Assy Muffler Comp Honda GX160K1HX2 Engine Fueltank Assy RUBBER, Supporter Honda GX160K1HX2 Engine Flywheel Assy FAN, Cooling Honda GX160K1HX2 Engine Ignition Coil Assy Coil ASSY., Ignition Honda GX160K1HX2 Engine Control Assy ARM, Governor Honda GX160K1HX2 Engine Gear Reduction Assy CASE, Reduction Honda GX160K1HX2 Engine Label Assy Enblem Terms and Conditions of Sale Stow Construction Equipment Page Your Local Dealer is

MS15E, MS15H5.5 specifications

The Stow MS15H5.5 and MS15E represent advanced options in the realm of industrial cleaning machinery, specifically designed for effectiveness and efficiency in various cleaning applications. These models cater to the demands of different environments, such as warehouses, retail spaces, and manufacturing facilities.

The MS15H5.5 is powered by a robust Honda engine, delivering superior cleaning power while ensuring reliability and longevity. This model features a high-pressure washer that efficiently tackles tough grime and stains, making it ideal for heavy-duty cleaning tasks. The Honda engine is known for its fuel efficiency, allowing for longer operational use without frequent refueling. It boasts a durable design with a reinforced steel frame, providing stability and toughness to withstand rigorous use.

On the other hand, the MS15E is an electric model that offers a quieter alternative for cleaning operations where noise reduction is crucial. This electric version is equipped with a powerful motor that provides consistent pressure for effective cleaning. The MS15E is valued for its ease of use and lower maintenance requirements compared to its gas-powered counterpart. Users appreciate its lightweight construction, which makes it easily maneuverable for various cleaning tasks.

Both the MS15H5.5 and MS15E incorporate advanced technology features such as an adjustable pressure setting, giving users better control over the cleaning intensity based on the surface being cleaned. This feature not only enhances cleaning efficacy but also extends the lifespan of the equipment and surfaces being serviced.

Safety is another critical aspect of both models. They come equipped with thermal relief valves that prevent overheating, ensuring safe operation during prolonged use. The ergonomic design of the handles and controls provides comfort to the operator, reducing fatigue during extended periods of cleaning.

In summary, the Stow MS15H5.5 and MS15E are versatile cleaning machines that excel in performance, durability, and user-friendliness. Whether powered by gas or electricity, these models are designed to tackle various cleaning challenges effectively, making them valuable assets for any cleaning operation.