STOW CMS-6S CONCRETE MIXER —TOWING GUIDELINES
Towing Safety Precautions
CAUTION:
■Check with your county or state safety towing regulations department before towing your mixer.
To reduce the possibility of an accident while transporting the mixer on public roads, always make sure that the mixer towing components and the towing vehicle are in good operating condition and both units are mechanically sound.
The following list of suggestions should be used when towing the mixer:
■Make sure that the hitch and coupling of the towing vehicle are rated equal to, or greater than the trailer "gross vehicle weight rating" (GVWR).
■ALWAYS inspect the hitch and coupling for wear. NEVER tow the mixer with defective hitches, couplings, chains etc.
■CHECK the tire air pressure on both the towing vehicle and the trailer. Also check the tire tread wear on both vehicles.
■ALWAYS make sure the mixer is equipped with a "Safety Chain".
■ALWAYS attach trailer's safety chain to the frame of towing vehicle.
■ALWAYS make sure that the towing vehicle's directional, backup, and brake lights are working properly.
■Remember in most cases the maximum speed unless otherwise posted for highway towing is 45 MPH, however before towing your mixer, check your local state, and county vehicle towing requirements. Recommended
■Place chocked blocks underneath wheels to prevent rolling, while parked, if disconnected from towing vehicle.
■Inflate tires to correct pressure, inspect tires for cuts, and excessive wear. See Table 16 (Tire Wear Troubleshooting).
■When towing of the mixer is required, place the drum in the up position (mouth facing upwards).
■ALWAYS make sure that the fuel valve lever is in the OFF position (gasoline models only).
■Check wheel mounting lug nuts with a torque wrench. Torque wheel lug nuts as described in the maintenance section of this manual.
■Check tightness of
■Avoid sudden stops and starts.This can cause skidding, or jackknifing. Smooth, gradual starts and stops will improve gas milage.
■Avoid sharp turns to prevent rolling.
CAUTION:
If the mixer tow bar is deformed or damaged replace entire tow bar. NEVER tow the mixer with a defective tow bar. There exist the possibility of the trailer separating from the towing vehicle.
Tow Bar to Vehicle Connection (Coupler Only)
1.Check the vehicle hitch ball, and mixer's coupler for signs of wear or damage. Replace any parts that are worn or damaged before towing.
2.Use only a
3.After tow bar has been connected to mixer (see next page), attach mixer's coupler to the hitch ball on the towing vehicle securely and make sure the lock lever is in the down position (locked).
Mixer Tow Bar Vehicle Connection (Pentile and Loop)
1.Make sure the bumper on the towing vehicle is equipped to handle either a pentile or loop type tow bar configuration.
2.After tow bar has been connected to mixer (see next page), secure either type of tow bar to the towing vehicle, following state and county towing regulations.
3.As a minimum, use a
PAGE 16 — STOW