Spirit FOLIO SX mixer manual Balance, 12 PFL

Page 14

1

4

2

3

5

6

7

8

9

10

11

12

AUX SEND 2

This is normally POST-FADE, and would typically be used as an effects send, but may be switched globally to PRE-FADE using the POST/PRE switch on the Master section, pro- viding a second foldback or monitor send if required.

AUX SEND 3

This is always POST-FADE.

8BALANCE

This control sets the amount of the channel signal feeding the Right and Left MIX or SUB buses, allowing you to balance the source in the stereo image. When the control is turned fully right or left you feed only that side of the signal to the mix. Unity gain is pro- vided by the control in the centre-detented position.

9ON

All outputs from the channel except inserts are muted when the ON switch is released and enabled when the switch is down.

10 MIX / SUB

The channel signal may be routed in stereo to either the main MIX (switch UP) or SUB buses (switch DOWN). The left/right balance is set by the BAL control (see above).

11 FADER

The 100mm FADER gives you smooth control of the overall signal level in the channel strip, allowing precise balancing of the various source signals being mixed to the Master Section. It is important that the input level is set correctly to give maximum travel on the fader which should normally be used at around the `0’ mark. See the `Initial Set Up’ sec- tion on page 16 for help in setting the right level.

12 PFL

When the latching PFL switch is pressed, the pre-fade signal is fed in mono to the head- phones, control room output and meters, where it replaces the selected monitor source (MIX, SUB or 2TK). The PFL/AFL LED on the Master section illuminates to warn that a PFL is active. The Left and Right meters display the PFL signal in mono. This is a useful way of listening to any required input signal without interrupting the main mix, for making adjustments or tracing problems.

Page 13

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Page 9/12 Page Safety Precautions Installation and Safety PrecautionsInstalling the Mixer IntroductionConnecting IT UP Line Input Wiring UPMIC Input Insert PointMIX Inserts Stereo Inputs 13/14 & 17/18Stereo Inputs 15/16 & 19/20 MIX & SUB OutputsAUX Outputs HeadphonesPolarity Phase Channel Direct OutputsFault Finding Guide Insert Point Alternative Direct Send Getting to Know Your Console Mono Input ChannelDirect Output HF EQ Sens Equaliser MID EQDirect PRE/POST PANFader MIX/SUB Stereo Input ChannelLevel GainBalance 12 PFLMaster Section Mono SUM AUX AFLsAUX 2 POST/PRE Master FadersInitial Set Up Using Your Folio SX ConsoleMicrophone Placement Page Advanced Features Using the Folio SX on Location Using Delay in Reinforcement Systems Application 1 Live Sound ReinforcementApplication 2 Multispeaker Applications Application 3 Places of WorshipApplication 4 Recording Application 5 Linking TWO Folio SX ConsolesGlossary General PrecautionsCare of Your Mixer Page Typical Specifications NoiseFitting the Rack MounT Option DimensionsRack Mount Option Appendix 1 Typical Connecting Leads Page Diagram Page Harman International Company
Top Page Image Contents