Venturer CDG 62 Precautions, Parts Identification, Power Connection, TV Connection, Tape Playback

PRECAUTIONS

FOLLOW THE ADVICE BELOW FOR SAFE AND APPROPRIATE OPERATIONS.

PARTS IDENTIFICATION

POWER CONNECTION

HOUSE CURRENT

Before use, check that the rated voltage of your unit matches your local voltage.

Caution:

To prevent electrical shock, match wide blade of plug to wide slot, fully insert.

TV CONNECTION

When the unit is connected to a TV set of either NTSC or PAL color system, the video image from a CD-G (CD graphics) can be shown on the TV set.

•Sound from the disc is heard from the speakers of this unit.

•Only a TV set with the VIDEO input jack can be connected to watch graphics.

CONNECTION (A) - FOR ALL TV SETS WITH AUDIO AND VIDEO JACKS Connect the AUDIO and VIDEO jack of the unit to the AUDIO and VIDEO input jack of the TV set with the connection cable supplied.

ON PLACEMENT

•Do not use the unit in places which are extremely hot, cold, dusty, or humid.

•Place the unit on a flat and even surface.

•Do not restrict the air flow of the unit by placing it in a place with poor air flow, by covering it with a cloth, or by placing it on a carpet.

•Never obstruct the ventilation holes on the rear panel, as increased internal temperature may affect the electric parts. In particular, do not place the system in an airtight rack.

•If using the system near television or radio, interference may occur. Move this system away.

FCC INFORMATION (For U.S.A. only)

ON AC VOLTAGE

•Before use, check that the rated voltage of your unit matches your local voltage.

ON SAFETY

•When connecting or disconnecting the AC cord, grip the plug but not the cord itself. Pulling the cord may damage it and thus be hazardous.

•Disconnect from the AC mains, when the unit is not going to be used for some time.

•If the AC lead is broken or damaged or if the copper wires are exposed, contact a qualified engineer to replace.

BATTERIES

•Disconnect the AC power cord from the AC inlet of the unit. Battery power

•Open the batteries compartment and insert 9 x "D" size batteries as shown here:

•Do not mix old and new batteries. Do not mix ALKALINE, standard (CARBON-ZINC) or rechargeable (NICKEL-CADMIUM) batteries.

AUDIO OUTPUT

RL

VIDEO

OUTPUT

ÿþ

This device complies with part 15 of the FCC Rules. Operations is subject to the following two conditions:

(1)This device may not cause harmful interference, and

(2)This device must accept any interference received, including interference that may cause undesirable operations.

Should any trouble occur, disconnect the AC power cord and refer servicing to qualified personnel.

- 1 -

ADJUSTING THE SOUND

ÿþý ÿ￿￿

WHEN RECORDING

•The VOLUME, TONE and DIGITAL ECHO controls may be adjusted with no effect on the recorded signal.

•The PITCH control must be adjusted to the centre position. Otherwise distortion signal may be recorded.

LISTENING TO THE RADIO

1. Set the FUNCTION switch to the 2. Tune into the desired station. desired position (AM/FM).

TUNING

FOR BETTER RECEPTION

Repositioning the unit to get better reception.

TAPE PLAYBACK

3. Press the PLAY button to begin playback.

OR

TO STOP PLAYBACK

Press the STOP/EJECT button.

TO INTERRUPT PLAYBACK

Press the PAUSE button.

To resume play, press the PAUSE button again.

TO FAST WIND

Press the REWIND or F.FWD button.

Press the STOP/EJECT button to stop winding at the desired position.

WHEN THE TAPE REACHES ITS END

During fast wind or regular play, the tape will stop automatically when its end is reached.

WHEN BOTH DECK A AND DECK B ARE SET TO THE PLAYBACK MODE The sound from both decks will be mixed together.

NOTE:

The PITCH control must be adjusted to the centre position otherwise distortion signal may be played.

- 3 -

TAPE PLAYBACK - continued

FROM DECK A TO DECK B

TAPE DUBBING

DECK B

TO STOP DUBBING

Press the STOP/EJECT buttons of deck A and deck B.

MICROPHONE MIXING (KARAOKE)