Descriptions and Functions

1.AC VOLTAGE SELECTOR - Check to make sure that the AC Voltage Selector switch is set to the proper voltage for your area (120V/60Hz for the North America area) before plugging in the AC power cord to the AC power outlet.

CAUTION: Unplug the AC power cord from the AC power outlet before resetting the AC voltage selector switch.

2.FUSE - Please turn off the AC power and unplug the AC power cord before replacing the fuse. (ONLY replacing with the same type and rating of new fuse.When the AC VOLTAGE SELECTOR is set to 115V,the new fuse should have the rating of T6.3AL/250V..When theAC VOLTAGE SELECTOR is set to 230V,

the new fuse should have the rating of T4AL/250V.)

3.~115V/60Hz ~230V/50Hz AC Power Input Terminal

4.Speaker Output Terminals - Banana jacks are used as the speaker output terminals. The overall effective impedance of the speaker sets to each side (left or right side) of the speaker terminals needs to

be within the range of 4 To 16 . (Caution: If two sets of 8 speakers are connected to the same speaker terminal, the effective impedance of these two speakers will be 4 , just one half of its original impedance.)

5.KEY CONTROLLER - This KEY CONTROLLER 3.5mm input jack is to be connected to some special equipment, such as a key control microphone.

6.VOLUME RESET - When this VOLUME RESET is switched to the OFF position, both the MIC MASTER VOLUME knob and the MUSIC MASTER VOLUME knob will stay where they are after the main power is turned on (after the power-on process). When this VOLUME RESET is switched to the ON position, both the MIC MASTER VOLUME knob and the MUSIC MASTER VOLUME knob will be turned to the minimum position automatically after the main power is turned on.

7.Cooling Fan

8.MIC INSERT - These are the TRS ¼” microphone effect inserts. The tip of the insert is used as the audio signal output (to the sound effect equipment), the ring of the insert is used as the audio signal input (from the sound effect equipment), and the sleeve is used as the ground. The MIC1 is the microphone effect insert for the MIC1 input. The MIC2/3 is the microphone effect insert for the MIC2 and MIC3 inputs.

9.VIDEO INPUT - There are two video inputs, VCD and DVD.

10.VIDEO OUT - There are two independent video output jacks (each with its own driver).

11.MIC AUDIO OUTPUT - This audio output comprises the microphone audio signal only.