The Singing Machine STVG-707 instruction manual Antenna

Page 4

ENGLISH

IMPORTANT SAFETY INSTRUCTIONS

15.Outdoor Antenna Grounding - If an outside antenna is connected to the receiver, be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information with regard to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna-discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. See figure:

 

ANTENNA

 

LEAD IN

 

WIRE

GROUND

 

CLAMP

 

 

ANTENNA

ELECTRIC

DISCHARGE UNIT

(NEC SECTION 810-20)

SERVICE

 

EQUIPMENT

 

 

GROUNDING CONDUCTORS

 

(NEC SECTION 810-21)

 

GROUND CLAMPS

NEC-NATIONAL ELECTRICAL CODE

POWER SERVICE GROUNDING

S2898A

ELECTRODE SYSTEM

 

(NEC ART 250. PART H)

16.Lightning - For added protection for this product during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the product due to lightning and power-line surges.

17.Power Lines - An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.

18.Overloading - Do not overload wall outlets, extension cords, or integral convenience receptacles as this can result in a risk of fire or electric shock.

19.Object and Liquid Entry - Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short-out parts that could result in a fire or electric shock. Never spill liquid of any kind on the product.

20.Servicing - Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.

21.Damage Requiring Service - Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions:

a)When the power-supply cord or plug is damaged,

b)If liquid has been spilled, or objects have fallen into the product,

c)If the product has been exposed to rain or water,

d)If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation.

e)If the product has been dropped or damaged in any way, and

f ) When the product exhibits a distinct change in performance - this indicates a need for service.

22.Replacement Parts - When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, or other hazards.

23.Safety Check - Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition.

24.Wall or Ceiling Mounting - The product should be mounted to a wall or ceiling only as recommended by the manufacturer.

25.Heat - The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat.

E3

Image 4
Contents STVG-707 Dripping Warning Ventilation WarningImportant Safety Instructions Antenna Introduction Control Locations Front ViewMaster Volume Fast Forward CDG LEDVertical Hold Rear ViewConnecting Power Connecting to Your TVMaking the Connections Video ConnectionCommon Ways to Configure Your TV or VCR Connecting a Video Component for InputConnecting AN Audio Component for Input Audio ConnectionAntenna Connection ROD Antenna 75 OHMTurning Power ON/OFF CD or CD+G OperationPreparation Playing CD or CD+G DiscPLAY/PAUSE Mode Stop ModeSkip Playfor Both CD and CDG Discs Search for Audio CD Disc onlyTV Operations TV Broadcasting ReceptionSing Along TV Broadcasting Recording Sing Along TV BroadcastingCassette Operations PlaybackMICROPHONES/ECHO/PITCH Sing Along TapeRadio and Other Operations AM/FM RadioSing Along Radio Recording Sing Along RadioCare and Maintenance Cleaning DiscCompact Disc Cassette Deck CareTrouble Shooting Guide Problem Possible Cause SolutionOFF CD PlayerVCR CassetteE19 Specifications Singing Machine Karaoke Glossary of Terms EchoLimited Warranty and Service Singing Machine Company, Inc