ECOUSTIC® E110
SPECIFICATIONS
POWER AMPLIFIER SECTION: Rated Power & Load:
100W into 8 Ohms (internal with DDT compression)
Frequency Response:
+0,
Total Harmonic Distortion:
Less than 0.5%, 1W to 50W(rms), 20Hz to 20kHz, 8 Ohms
DDT Dynamic Range:
Greater than 20dB
DDT Maximum THD:
Below 0.5% THD for 6dB overload Below 1% THD for 20dB overload
Hum & Noise:
Greater than 90dB below rated power
Power Consumption:
150W, 60 Hz, 120 VAC (domestic) 150W, 50/60 Hz,
PREAMP SECTION:
The following specs are measured
@1kHz with the controls preset as follows:
Channel 1 Gain @ 5
Graphic EQ Sliders @ 0 dB
Notch Filter @ 0dB
Channel 2 Gain @ 5
Low EQ @ 0 dB
High EQ @ 0 dB
All Effects Bypassed
Master Volume @ 5
Channel 1 -1/4" Input:
Impedance: High Z, 10M Ohms
Nominal Input Level:
Maximum Input Level: 3.52dBV, 1.50V(rms)
Channel 1 - XLR Input:
Impedance: Low Z, 8.2k Ohms
Nominal Input Level:
Maximum Input Level:
Channel 1 - Equalization:
Frequency Centers (Hz) at 63, 125, 250, 500, 1k, 2k, 4k, 8k, 16k
Available
Channel 1 - Notch Filter:
Available 18dB of cut at 150Hz
Channel 2 - 1/4" Input:
Impedance: High Z, 10M Ohms
Nominal Input Level:
Maximum Input Level: 3.52dBV, 1.50V(rms)
Channel 2 - XLR Input:
Impedance: Low Z, 8.2k Ohms
Nominal Input Level:
Maximum Input Level:
Channel 2 - Equalization:
Low and High
Corner Frequencies at 80Hz and 8kHz, respectively
Available
Balanced XLR Line Output (rear): Output Impedance: 150 Ohms
Nominal Output Level: 3.23dBV, 1.45V(rms)
Available Ground Lift capability
System Hum & Noise @ Nominal Input Level:
(20Hz to 20kHz
External Footswitch (not included): Peavey Part # 03582670
See manual text for functional details
Dimensions & Weight:
18.0” H x 20.7” W x 14.7” D (458mm H x 526mm W x 374mm D)
45.0 lbs (20.4kg)
16