Rear Panel
30
27
28
29
31 | 32 | 33 | 34 | 35 | 36 | 37 | 38 | 39 | 40 | 41 | 42 |
27 ground polarity switch
The ground switch is a
28 reset/circuit breaker switch
Use this switch to restore power to the unit when the internal breaker is tripped. Turn the power switch to the off position before resetting the breaker. To reset‚ push the reset button in and release it. Turn the unit back on and confirm that the power LED is on. If the breaker is tripped again upon
29 IEC connector/detachable line cord
For your safety‚ we have incorporated a detachable‚
30 speaker output jacks
There are two 1/4" jacks and one Neutrik type jack that provide the powered signal from the amplifier. Each connector is electrically the same (parallel). Use one of the jacks to connect your speaker cabinet and the other to add a second speaker cabinet in parallel. The minimum speaker load impedance is 2 Ohms or two 4 Ohm speakers in parallel.
Warning: To prevent the amplifier from overheating‚ the front and rear fan vents should remain clear of obstructions.
31 power amp input
Used to connect a line level signal to the power amplifier (i.e. external preamp). This jack‚ when used‚ disconnects the internal preamp.
32 preamp out
The preamp output can be used to route the amplified signal to a mixing console‚ tape recorder or other device. Connect the preamp output using a shielded cable to an input of one of these devices. This does not affect the operation of the amplifier. The preamp out and power amp in jacks can also be used as a line level effects patch point.
33 remote jack switch
Provided for an optional footswitch. Allows remote selection of the input mute and the effects loop. Mute switch on front panel must be depressed to the IN position for the footswitch to function properly.
34 effects return
Input for returning signals from an external
7