SETUP
Lamp
You will need to install a lamp prior to the initial operation of the fixture. Two 64514 300w halogen lamp are included. This lamp is used on both the 115V and 230V versions of the Cyborg™
Warning!
When replacing the lamp, please wait 15 minutes after powering down to allow the unit to cool down! Always disconnect from main power prior to lamp replacement.
For lamp installation in 230V environments please read “Lamp
Appendix section of this manual.
Mounting
Do not touch the envelope (glass area) of the
bulb with bare hands. If this happens, clean the
lamp with alcohol and wipe it with a lint free cloth
before installation.
L AM P I N ST ALL AT I ON
1)Remove the’s topthreecover(S1) screws that surround
the fixture.
2)If replacing the lamp, remove old lamp first.
3)Reach in and using a cloth or napkin hold the bulb and pull out of the lamp socket located inside the reflector.
4)Replace with a new lamp.
5)Replace fixture cover, align the screw holes and fasten the screws.
6)No lamp alignment is necessary for this fixture since the lamp is already optimized inside the reflector.
S1
Lamp exposed
(3)thumb screws surround and fastens the top cover to the fixture, the remaining (2) are not seen in this picture
Lamp inside the reflector
∙
∙
∙
Note!
ORI ENT AT IO N
This fixture may be mounted in any position provided there is adequate room for ventilation.
RIGG ING
Hanging Clamp
It is important never to obstruct the fan or vents pathway. Mount the fixture using, a suitable “C” or “O” type clamp. Adjust the angle of the
fixture by loosening both knobs and tilting the fixture. After finding the
desired position, retighten both knobs.
When selecting installation location, take into consideration lamp replacement access and routine maintenance.
Safety cables should always be used.
Never mount in places where the fixture will be exposed to rain, high humidity, extreme temperature changes or restricted ventilation.
Clamps sold separately!
5 |