N.POWER SWITCH - Switches the amplifier
O.IEC POWER SOCKET - Connect the power cord (included) to a grounded AC receptacle in compliance with the voltage and frequency ratings specified on the rear panel of your amplifier.
P.TUNER - Connect your guitar tuner here. Use MUTE {I} to silence audio output while tuning.
Q.LINE OUT - Balanced XLR jack for output to sound reinforcement and recording equipment.
Rear Panel 
7
R.GROUND LIFT - Disconnects the LINE OUT {Q} ground connection
GROUNDED (normal) |
| GROUND LIFTED |
| ||
|
S.PRE/POST EQ - Supplies the LINE OUT jack with the signal either before or after it is processed by the amplifier’s tone and equalization circuits.
PRE (tone/EQ bypassed)
POST (tone/EQ active)
T.LINE OUT LEVEL - Adjusts the signal output level of the LINE OUT jack {Q}.
U.FOOTSWITCH - Connect the included footswitch to enable remote
V.FX SEND / FX RETURN - (1) Effects Loop - Connect FX SEND to your effects input and effects output to FX RETURN. (2) Multiple Amps - Connect FX SEND on the primary unit to FX RETURN on the auxiliary unit. The primary unit controls all auxiliary units.
Specifications
TYPE: |
| PR 411 |
|
|
PART NUMBERS: |
| 2289500000 (120V, 60Hz) USA | 2289503000 (240V, 50Hz) AUS | 2289504000 (230V, 50Hz) UK |
|
| 2289506000 (230V, 50Hz) EUR | 2289507000 (100V, 50Hz) JPN |
|
POWER REQUIREMENT: | 540W |
|
| |
PREAMP | INPUT IMPEDANCE: | NORMAL: 1MΩ |
| |
SENSITIVITY AT FULL POWER: | NORMAL: 19mV |
| ||
| NOMINAL LEVEL: | NORMAL: 145mV |
| |
POWER AMP | SENSITIVITY: | 1.4V R.M.S., 1kHz |
|
|
| POWER OUTPUT: | 200W R.M.S. into 4Ω @ < 0.1% T.H.D., 1 kHz |
| |
TONE CONTROLS | EQ TILT: | ±10dB, crossover frequency: 350Hz |
|
|
| BASS/TREBLE: | BASS: ± 15dB @ 50Hz | TREBLE: ± 15dB @ 10kHz |
|
MID FREQ: 200Hz to 1.0kHz | MID LEVEL: ±15dB @ MID FREQ setting | |||
EFFECTS LOOP | IMPEDANCES: | SEND: 1kΩ | RETURN: 11kΩ |
|
| NOMINAL LEVEL: | +4dBu (adjustable with level control) |
|
|
FOOTSWITCH: |
| Three button, included: Reverb, Tuner Mute, Effects Loop (064544) |
| |
SPEAKER: |
| One 15", 4Ω Fender® Custom 15 Driver, made in USA by Eminence® (064398) |
| |
FITTED COVER: |
| Included (065532) |
|
|
DIMENSIONS: |
| HEIGHT: 21 in (53.3 cm) | WIDTH: 20 in (50.8 cm) | DEPTH: 12.5 in (31.8 cm) |
WEIGHT: |
| 65 lb (29.5 kg) |
|
|
Product specifications are subject to change without notice.
✧ www.f e n d e r.com ✧