Section 5 | In Use | DriveRack® |
7.Rename the Input by pressing Encoder #2 and using Encoder #1 and Encoder #2 to select characters and advance the cursor.
8.Store the name by pressing the STORE/DELETE button.
9.To change the Mid Router to a Mixer, press the Output 6 button and then the MIX/ROUTE button, then turn Encoder #1 to select Mixer.
10.While on Output 6, press the DELAY button to allocate enough Delay for these speakers.
11.Load this configuration by pressing the RTA/LOAD button, and one more time to confirm this configuration change. You’re returned to Edit mode and the main preset screen.
Once the configuration loads, the change is now active and audio can be passed through this new configu- ration. Now we’ll edit the processing function parameters in the Bandpass filter, Compressor and Graphic EQ, and create the correct mono mix for our Delayed speakers. To do this we take the following steps:
1.Press the OUTPUT CHANNEL 1 button and the BANDPASS button to navigate to the Bandpass fil- ter on Output 1.
2.Edit the parameters found on page 1 of that menu (Lowpass Filter Frequency and Slope). The name of the output that is being edited is shown in the upper right corner; the total number of pages is shown in the upper left corner.
3.Press NEXT to access the next page of parameters. Continue until all desired pages of parameters have been edited.
®
34 | DriveRack® 4800/4820 User Manual |
|
|