DriveRack® | Getting Started | Section 1 |
9. Zone Control Inputs 1-12 (RJ-45)
These
10.Word Clock BNC Connection
This connection allows the DriveRack 4800 or 4820 to lock to a master system clock. It is not ter- minated. For best results we recommend using "T" connectors when setting up a BNC Word Clock network and terminating the end of of this network with a 75 ohm BNC terminator. (See Appendix 6).
11. Pin Lift Switch
Analog Inputs 1&2, and 3&4 of the DriveRack 4800/4820 share a Ground Lift Switch (Pin 1 lift).
System ground loops can cause hum; this hum can be reduced by pressing the Ground Lift Switch.
1.2 - Front Panel (4800)
1 | 2 | 3 | 4 | 5 |
6 | 7 | 8 | 9 | 10 |
1. LCD Display
The color 1/4 VGA (320x240) display provides viewing of all parameters and attributes of the DriveRack 4800.
2. Function Buttons
The Function buttons of the DriveRack 4800 allow direct access to all editing and navigating functions of the DriveRack 4800. The functions of the aforementioned buttons are as follows:
PREV is used to navigate back through the various pages of any module. Pressing and holding the PREV button allows you to enter Copy/Paste Mode, where subsequent presses of PREV allow copying all the function DSP parameters.
NEXT is used to navigate forward through the various pages of any module. Pressing and holding the NEXT button allows you to enter Copy/Paste Mode, where subsequent presses of NEXT allow pasting of all the function DSP parameters.
EQ 1 is used to select and/or enter the first Input EQ module or the Output EQ module.
EQ 2 is used to select and/or enter the second Input EQ module or the Output EQ module.
BANDPASS is used to select and/or enter the Bandpass/Crossover function.
®
DriveRack® 4800/4820 User Manual | 3 |
|
|