Audio Jack
To attach the audio jack to the guitar body:
1.Solder the wires shown in Figure 26 to the tabs on the audio jack.
Figure 26. Soldered audio wire.
2.Turn the audio jack over and insert it in the cavity on the guitar body.
3.Secure the position of the audio jack to the guitar body with masking tape.
4.Using a 3⁄32" drill bit, drill 1⁄2" deep holes straight through the two holes in the audio jack. Note—Drilling the holes deeper than 1⁄2" could result in drilling out through the back of the guitar body.
5.Secure the audio jack to the guitar body with the included two 1⁄2" wood screws.
Winding Strings
The correct position of the guitar strings is shown in Figure 27. The thin High E string is called the "1st" string and the thick Low E string is called the "6th" string.
E
6
5
A
4
D
3 G
2 B
1 E
Figure 27. Correct string locations.
To install the guitar strings:
1.Slide the 1st guitar string through the corre- sponding hole in the back plate (Figure 28).
Figure 28. 1st string installation hole.
H3123 Electric Guitar Kit |