Specifications, Inputs, Outputs, General

1.Unscrew the outside FADER PLATE SCREWS (B).

Do not touch the INSIDE SCREWS (C).

2.Carefully lift the fader and unplug the CABLE (D).

3.Plug the new fader into the cable and place it back in the mixer.

4.Screw the fader to the mixer.

7.OUTPUT CONTROL SECTION: The level of the MASTER OUT (31) is controlled by the MASTER (23) slide. The Master TREBLE (20) and BASS (21) controls allow you to adjust the output of channels 1-4.

NOTE: THE RECORD OUT (27) HAS NO LEVEL CONTROL. THE LEVEL IS SET BY THE CHANNEL SLIDES OF THE SELECTED CHANNEL.

8.TALKOVER SECTION: The purpose of the talkover section is to allow the program playing to be muted so that the MIC can be heard above the music. The MIC 1/TALKOVER SWITCH (6) controls MIC 1 and has three settings. When the MIC 1/TALKOVER SWITCH (6) is in the bottom position, the MIC and talkover are off. When the MIC 1/ TALKOVER SWITCH (6) is in the center position MIC 1 is on, the MIC 1 INDICATOR (7) will glow, but talkover is off. When the MIC 1/TALKOVER SWITCH (6) is in the top position, MIC 1 and talkover will be on and the volume of all sources except the MIC input are lowered by 16dB. The MIC LEVEL (16) controls the level of MIC 1.

9.CUE SECTION: By connecting a set of headphones to the HEADPHONE (5) jack, you can monitor any or all of the channels. Press the CUE ASSIGN (19) buttons for channels 1-4to select the channel or channels to be monitored and their respective LED indicators will glow. Use the CUE LEVEL (24) control to adjust the cue volume without effecting the overall mix. By moving the CUE PGM PAN (22) control to the left you will be able to monitor the assigned cue signal. Moving the control to the right will monitor the PGM (program) output.

10.DISPLAY: The DISPLAY (18) indicates the MASTER output left and right levels.

SPECIFICATIONS:
INPUTS:
MIC 1		1.5mV 2kOhm balanced
MIC 2		1.5mV 2KOhm balanced
Phono @ 1kHz		2mV 47kOhm
Line		100 mV 27kOhm
OUTPUTS:
Amp/Booth		0 dB 1V 400Ohm
	Max	....................20V Peak to Peak
Rec		225mV 5kOhm
GENERAL:
Bass		± 12dB
Treble		± 12dB
Frequency Response		20Hz - 20KHz +/- 2dB
Distortion		less than 0.02%
S/N Ratio		better than 80dB
Talkover Attenuation		-16dB
Power Source:		Adapter-115V/15V AC 0.5A
..........................................................		or 230V/15V AC 0.5A
Dimensions	19”w x 3”d x 7”h (483 x 76 x 178 mm)
Weight		6.25lbs (2.84 kg)

( 4 )

SPECIFICATIONS:

INPUTS:

OUTPUTS:

GENERAL: