Behringer PMH660M/PMH880S Wiring Examples, Europower mixer as a stereo amplifier Example

Page 10

EUROPOWER PMH660M/PMH880S

5. WIRING EXAMPLES

For stereo operation the POWER AMP switch of the PMH880Smust be set to its upper position (MAIN L/MAIN R). Outputs A and B deliver the stereo main signal to the P.A. speakers. Two active speakers, wired in parallel, are connected to the PREAMP MONITOR output. They are used as on-stage monitor speakers. The effects processors can be switched on and off with a dual footswitch. This set-up is not possible with the PMH660M (no stereo operation possible).

Fig. 5.1: EUROPOWER mixer as a stereo amplifier

(example)

Both the PMH880S and the PMH660M can be set-up for dual

mono operations. The POWER AMP switch must be set to its lower (PMH660M) or center position (PMH880S). The two loudspeaker outputs provide the main and the monitor signals independently of each other and to two loudspeakers each, which are wired in parallel.

Fig. 5.2: EUROPOWER mixer as a dual mono amplifier

(example)

10

5. WIRING EXAMPLES

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Europower Europower PMH660M/PMH880S Important Safety InstructionsTable of Contents ForewordBefore you get started IntroductionControl Elements ManualEffects section List of all multi-effects presetsPlease refer to and as well as .4 Loudspeaker connectors Main and monitor sectionRear panel ConnectorsLoudspeaker Output B Digital Effects Processor Audio connections InstallationMains connection Loudspeaker connectionOutput B Output a Bridge Wiring Examples Europower mixer as a stereo amplifier ExampleStandard set-up example Specifications PMH660M PMH880S Microphone InputsWarranty § 1 Warranty CARD/ONLINE Registration § 2 Warranty
Top Page Image Contents