DX4 Controls and Features | American Audio specs

DX4™	Controls and Features Cont.

22.GND (GROUND TERMINAL) - Connect each of your turntables ground leads to either of the two ground terminal. This will reduce the humming and popping noises associated with magnetic phono cartridges.

23.CHANNEL 2: PHONO 2 INPUT JACKS - Connect turntables equipped with MM pickup cartridge to PHONO inputs only (All DJ turntable use MM pick-up cartridges). CD players or Tape Decks and other line level instruments should not be connected to these jacks. The red colored RCA jack repre- sents the right channel input and the white represents the left channel input.

24.CHANNEL 1: PHONO 1 INPUT JACKS - Connect turntables equipped with MM pickup cartridge to PHONO inputs only (All DJ turntable use MM pick-up cartridges). CD players or Tape Decks and other line level instruments should not be connected to these jacks. The red colored RCA jack repre- sents the right channel input and the white represents the left channel input.

25.RCA BOOTH OUTPUTS JACKS - These RCA jacks send a low current unbalanced output signal and are controlled by the BOOTH LEVEL (13) volume control. These jacks should only be used for shorter cable runs to signal processors or looping to another mixer.

26.CHANNEL 4: LINE 5 INPUT JACKS - These Jacks are used for line level inputs. Connect CD players or Tape Decks to LINE inputs. Line level musical instruments with stereo outputs such as Rhythm Machines or Samplers should also be connected to LINE inputs. Turntables should only be connected to “Phono” inputs. The red colored RCA jack represents the right channel input and the white represents the left channel input. Volume will be controlled by the channel four FADER (4).

27.CHANNEL 3: LINE 3 INPUT JACKS - These Jacks are used for line level inputs. Connect CD players or Tape Decks to LINE inputs. Line level musical instruments with stereo outputs such as Rhythm Machines or Samplers should also be connected to LINE inputs. Turntables should only be connected to “Phono” inputs. The red colored RCA jack represents the right channel input and the white represents the left channel input. Volume will be controlled by the channel three FADER (4).

28.CHANNEL 2: LINE 2 RCA INPUT JACKS - These Jacks are used for line level inputs. Connect CD players or Tape Decks to LINE inputs. Line level musical instruments with stereo outputs such as Rhythm Machines or Samplers should also be connected to LINE inputs. Turntables should only be connected to “Phono” inputs. The red colored RCA jack represents the right channel input and the white represents the left channel input. Volume will be controlled by the channel three FADER (4).

29.CHANNEL 1: LINE 1 RCA INPUT JACKS - These Jacks are used for line level inputs. Connect CD players or Tape Decks to LINE inputs. Line level musical instruments with stereo outputs such as Rhythm Machines or Samplers should also be connected to LINE inputs. Turntables should only be connected to “Phono” inputs. The red colored RCA jack represents the right channel input and the white represents the left channel input. Volume will be controlled by the channel three FADER (4).

30.MICROPHONE 1 CONNECTOR - This jack is used to a connect a microphone to the mixer. Con- nect you microphone via 1/4 inch (6.3mm) jack. The signal volume will be controlled by the MIC 1 VOLUME KNOB (1)

31.MICROPHONE 2 CONNECTOR - This jack is used to a connect a microphone to the mixer. Con- nect you microphone via 1/4 inch (6.3mm) jack. The signal volume will be controlled by the MIC 2 VOLUME KNOB (1)

DX4™

Controls and Features Cont.