AA35 MIXER AMPLIFIER
20 19 18
OWNER'S MANUAL
Unswitched Outlet | Outlet Breaker | Pre Out Line Out A | Input 3 | Input 2 |
120V AC 60Hz | 125V AC 4A |
|
|
|
Max 500W | Push Reset |
|
|
|
LL
77)+
7jbWiIekdZ77I[h_[iC_n[h7 fb_\_[h
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
Zone 2 Assign | Mute Rcv | Phantom | Input1 | Low cut | |||
Input 3 | Input 2 | Input 1 | Input 3 | Input 2 |
|
|
|
Off | Off | Off | Off | Off | Off | Line/Tel | Off |
On | On | On | On | On | On | Mic | On |
21 | R | R |
Amp In Line Out B
Zone 2 Out
Zone2Mute
0 | 10 | 0 | 10 |
LevelSens
| Speaker Output 35W | 1W |
| Remote |
| |
|
|
| 8 | 600 | Mute | Input 1 |
| COM 8 | 25V 70V | - + | - + | G | - + |
120V AC 60Hz 100W | CLASS 2 WIRING | £Èä£Ê>VÊ V >ÞÊ Û`°]ÊÃ]Ê/8ÊÇx££Ê |
| |||
|
|
|
| |||
|
|
|
|
| ||
22
18.Pre Out
The PRE OUT connector allows Post tone control and low cut filter (when engaged) functions to
be available to drive another power amp or external audio device(s). Used in conjunction with the AMP IN connector, an effects loop can be created by connecting the PRE OUT jack to a device such as an equalizer then back out to the AMP IN connector. See Example 3 in the Setup section of this manual.
19.Amp In
The AMP IN connector is useful for converting the AA35 into a slave amp. When a line level signal is connected to this input, the internal connection between the preamp and internal power amp is broken. Audio signals applied to this connector are post tone control and input level controls.
20.Breaker
The circuit breaker is designed to trip and shut down the AA35 "Unswitched Outlet" upon an over current condition. After correcting the cause of the breaker tripping, reset the breaker by pushing in on the tab.
21.Unswitched Outlet
The unswitched outlet provides power for other devices (Atlas rack work light, etc.) and is live whenever the power cord is plugged into a live outlet. Total power draw must not exceed 500W.
22.Output Terminal Strip
For loudspeaker connections, connect as follows or proceed to the setup section for typical wiring schemes.
COM - Speaker common or negative connection 8Ω - Connect to direct coupled loudspeakers
25V - Connect to transformer coupled, 25V loudspeakers with a total load impedance of no less than 17.8Ω
70V - Connect to transformer coupled, 70.7V loudspeakers with a total load impedance of no less than 142.8Ω.
Specifications are subject to change without notice
AtlasSound.com
1601 JACK MCKAY BOULEVARD ENNIS, TEXAS 75119 U.S.A. • | TELEPHONE: (800) | FAX: (800) | ||
©2006 ATLAS SOUND LP | Printed in U.S.A. | 000106 | ATS002171 RevA 01/06 | PP |
|
|
|
| 10 |