AA35 MIXER AMPLIFIER | OWNER'S MANUAL |
9.Treble Control
Normally set at the 12:00 position, rotating clockwise will increase (boost) treble frequencies by 10dB at 10kHz. Rotating
REAR PANEL DESCRIPTION
Unswitched Outlet | Outlet Breaker | Pre Out Line Out A | Input 3 | Input 2 |
120V AC 60Hz | 125V AC 4A |
|
|
|
Max 500W | Push Reset |
|
|
|
LL
77)+
7jbWiIekdZ77I[h_[iC_n[h7 fb_\_[h
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
Zone 2 Assign | Mute Rcv | Phantom | Input1 | Low cut | |||
Input 3 | Input 2 | Input 1 | Input 3 | Input 2 |
|
|
|
Off | Off | Off | Off | Off | Off | Line/Tel | Off |
On | On | On | On | On | On | Mic | On |
| R | R |
|
Amp In | Line Out B |
|
|
|
| Zone 2 Out | |
Speaker Output 35W | 1W |
| |
|
| 8 | 600 |
COM 8 | 25V 70V | - + | - + |
Zone2Mute
0 | 10 | 0 | 10 |
Level |
| Sens | |
Remote |
|
|
|
Mute | Input 1 |
|
|
| G - | + |
|
120V AC 60Hz 100W | CLASS 2 WIRING |
| £Èä£Ê>VÊ V >ÞÊ Û`°]ÊÃ]Ê/8ÊÇx££Ê |
|
10
10.Multi Function Dipswitch
Understanding the functionality of the dipswitches is key to maximizing the versatility of the AA35. When a switch is in the up position, the function is "OFF"; when a switch is in the down position, the function is "ON".
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
|
|
|
|
|
|
|
|
Zone 2 Assign | Mute Rcv | Phantom | Input1 | Low cut | |||
|
|
|
|
|
|
|
|
Input 3 | Input 2 | Input 1 | Input 3 | Input 2 |
|
|
|
Off | Off | Off | Off | Off | Off | Line/Tel | Off |
|
|
|
|
|
|
|
|
On | On | On | On | On | On | Mic | On |
|
|
|
|
|
|
|
|
SWITCH 1- Zone 2 Assign - When "ON", will route signals from Input 3 to the Zone 2 Output terminals.
SWITCH 2- Zone 2 Assign - When "ON", will route signals from Input 2 to the Zone 2 Output terminals.
SWITCH 3- Zone 2 Assign - When "ON", will route signals from Input 1 to the Zone 2 Output terminals.
SWITCH 4 - Mute Receive - When "ON", Input 3 signals will be muted if a signal is present on Input 1 (Refer to Mute Sensitivity Control, number 16 on page 9), or if a contact closure is present on the remote mute terminals (Refer to Remote Mute Connector, number 11(B) on page 8).
SWITCH 5 - Mute Receive - When "ON", Input 2 signals will be muted upon a signal present on Input 1(Refer to Mute Sensitivity Control, number 16 on page 9), or if a contact closure is present on the remote mute terminals (Refer to Remote Mute Connector, number 11(B) on page 8).
Specifications are subject to change without notice
AtlasSound.com
1601 JACK MCKAY BOULEVARD ENNIS, TEXAS 75119 U.S.A. • | TELEPHONE: (800) | FAX: (800) | ||
©2006 ATLAS SOUND LP | Printed in U.S.A. | 000106 | ATS002171 RevA 01/06 | PP |
|
|
|
| 7 |