Basic operation, Naming a song, Stop key + FF key

Basic operation

p.14

In “2. Naming a song,” step 3 has been changed as fol- lows.

2. Naming a song

3Change the name of the song.

Use the “ ” “ ” buttons to move the cursor to the location of the character that you wish to change, and rotate the [VALUE] dial to modify the song name.

The buttons in the LCD screen have the following function.

“A../a..” buttons: Select the alphabetical character “A.” Press it again to select the lowercase “a”. “0...9” button: Select the numeral “0–9”. “Symbol” button: Select a symbol.

“Insert” button: Insert a space, moving the follow- ing characters backward.

“Space” button: Select a space (blank).

“Backsp” button: Delete the character before the cursor.

“Delete” button: Delete the character at the cursor.

“ClearAll” button: Delete the entire name.

p.14

Part of “3. Selecting an existing song” has been changed.

[STOP] key + [FF] key

Use this to select the previous or next-numbered song in the same drive.

•Hold down the [STOP] key and press the [FF] key to move to the end of that song. If you are already at the end of the song, you will move to the beginning of the next song.

p.36–

Fade Track and Normalize Track commands have been added to “Track editing.”

Fade-in/Fade-out: Fade Track

This command creates a fade-in or fade-out in the selected region (IN–OUT) of the recorded track data. You can also create crossfades by combining fade-in and fade-out for identical regions in two tracks.

•You can fade-in or fade-out the IN–OUTregion.

•A single or multiple tracks of data can be faded-in or faded-out simultaneously.

Boosting to an appropriate level: Normal- ize Track

If the recorded level is too low, you can use this com- mand to boost the selected region (IN–OUT) of track data to the maximum level that will not cause clipping.

•The peak value of the audio data in the IN–OUTregion is detected, and the level of the entire IN– OUT region is boosted as far as possible without causing the peak value to clip.

•The data of a single track or of adjacent tracks can be normalized simultaneously.

If data that was recorded at an extremely low level is normalized, any noise component it contains will be boosted by the same amount.

The function of IN, OUT, TO, and END times for each command

	IN	OUT	TO	END
Copy Track	Copy source	Copy source	Copy desti-	– – –
	start time	end time	nation start
			time

Insert Track	Blank insert	Blank insert	– – –	– – –
	start time	end time

Erase Track	Erase start	Erase end	– – –	– – –
	time	time

Delete Track	Delete start	Delete end	– – –	– – –
	time	time

Swap Track	Swap start	Swap end	– – –	– – –
	time	time

Reverse	Reverse	Reverse end	Reversed	– – –
Track	start time	time	copy destina-
			tion start time

Optimize	Optimize	Optimize	– – –	– – –
Track	start time	end time

Expansion/	Expand/com-	Expand/com-	Expand/com-	Expand/com-
Compres-	press start	press end ﬁlepress desti-		press desti-
sion Track	time		nation start	nation end
			time and	time
			expand/com-
			press result
			copy destina-
			tion start time

Fade Track	Fade start	Fade end	– – –	– – –
	time	time

Normalize	Normalize	Normalize	– – –	– – –
Track	start time	end time