Reference
2. SYSTEM
p.45
The symbol indicating foot switch polarity has been changed to “ 
”.
P1 Control: Foot switch/Control change device (pedal/MIDI) setting
2
�
1 | 3 | 4 |
1.Pol (FootSwPolarity) .........................................
Specifies the polarity of the foot switch.
Connect a foot switch (such as the separately sold
option) to the front panel [FOOT SWITCH] jack, and set this parameter so that the “
” symbol appears when the foot switch is pressed.
Refer to the D16 Owner’s Manual for details on 2, 3, and 4.
p.46–47
MIDI messages (control changes) can now be used to control mixer parameters.
An “MMC” tab page has been added.
1. GlobalCh (Global Channel) | [01...16] |
Specifies the global MIDI channel. |
|
This setting is required in the following cases.
•If you wish to control the effect by setting “Device”
•If you wish to transmit/receive program change messages to select scenes.
MIDI messages can be transmitted and received when you connect the D16V2 to the external MIDI device via MIDI and set the MIDI channel of the connected device to match the “GlobalCh” of the D16V2.
2. ProgramChange: Trans | [On, Off] |
This enables transmission of program change mes- sages.
Program changes are transmitted when you change scenes, or store/recall a scene.
3. ProgramChange: Recv | [On, Off] |
This enables reception of program change messages.
When a program change message is received, the scene will change.
4. ControlChange: Trans ................................. [On, Off]
This enables transmission of control change messages.
When you modify a mixer parameter, the correspond- ing control change will be transmitted.
Control changes transmitted from the D16V2 can be recorded on a
5. ControlChange: Recv | [On, Off] |
This enables reception of control change messages.
By receiving control changes that were previously recorded on a MIDI sequencer, you can control the cor- responding mixer parameters. For details on the parameters that can be controlled, refer to the MIDI implementation chart (→ p.21).
P2 MIDI: MIDI settings
2
3
5
4
1
The D16V2 lets you use MIDI to do the following things.
•Control effects (→ D16 p.33)
•Synchronize with a sequencer or other MIDI device
•Select scenes (→ D16 p.67)
•Use control changes to control mixer parameters.
P3 Sync: Synchronization settings
By synchronizing the D16V2 and an external MIDI sequencer, you can simultaneously play back 16 tracks of audio together with external MIDI tone generators.
The action of making the D16V2 operate at the same timing as a MIDI sequencer is called synchronization. The device that outputs the synchronization clock is called the master device, and the device that receives the synchronization clock is called the slave device. The D16V2 can function either as the master or the slave.
It is also possible to transmit MMC messages from a MIDI sequencer etc. to control playback or recording on the D16V2.
5