SUPER MICRO Computer m28sab/m28sab-oem manual Other Parts, Setup and Installation Steps

M28SAB Mobile Rack User's Guide

4-3 Other Parts

When using this mobile rack independent of a chassis, you may need the follow- ing parts.

•Two 4-pin power cords to connect the mobile rack to a power supply.

•SAS iPass cable, part numbers CBL-0108L (39 cm), CBL-0281L (75 cm) or CBL-0294L-01 are used to connect the SAS ports to the motherboard or RAID controller.

4-4 Setup and Installation Steps

Use the following list as a guide to set up and install the mobile rack. If this mobile rack is to be installed in a chassis, use the instructions in the chassis manual.

Mobile Rack Chassis Installation

1.Unpack and examine system parts.

2.Review all system and safety guidelines.

3.M28SAB: Install the system fan as described in section 4-7 of this manual (not required on M28SAB-OEM).

M28SAB-OEM: Reset jumper JP61 to "enable", pins 2 - 3, without the fan connected.

4.Install the hard drives.

5.Connect data and power cables.

4-5 General Safety Guidelines

•Always disconnect power cables before installing or removing any components from the computer, including the backplane.

•Disconnect the power cable before installing or removing any cables from the mobile rack or backplane.

4-2